How To Remove Stock P5 Side Skirts??

[SP5]

I need to remove my stock P5 side skirts but I'm not quite sure how they come off. I know there are push screws on the front fender and clips along the bottom, but how do I unclip them? I'm sure its not that difficult but I don't want to break anything by fooling around with it.

I did a search for a How-To on this subject but didn't find one.

Any guidance would be greatly appreciated...

SP5
(uhm)

 

[mcstark]

Check this out: http://protege5.ugly.net/#ENG
You want section 09-16, and scroll down to the fourth page.
The section titled: Side Step Molding Removal/Installation.

Repeat after me: The Online Service Manual is my friend!

That should get you going...good luck!

 

[SP5]

Thanks! I will take a look.

SP5
(RTM)

 

[SP5]

Just removed my stock skirts. Not as hard as I thought it would be. It has like 14 clips on each side that just pop out by pulling out and up. If you're careful like I was, you should be able to pull them off without breaking any clips, I only broke one clip on each side.

Thanks for your input Mcstark!

SP5
(yippy)

 

[mcstark]

Just removed my stock skirts. Not as hard as I thought it would be. It has like 14 clips on each side that just pop out by pulling out and up. If you're careful like I was, you should be able to pull them off without breaking any clips, I only broke one clip on each side.

Thanks for your input Mcstark!

SP5
(yippy)

No problem...that's why the forums rock! Just glad I could help.