Thank you and nope. Hyperdip is made by the same guy who created Plastidip. Just like Plastidip you peel the excess off. The Hyperdip is fairly new, has a smoother finish and you can get it in gloss or metallic finishes as well as satin.
With Plastidip you would have to spray glossifier on to achieve that glossy look. Even then it would have a 'rough' finish vs smooth.
Yes it does Bruce and that is what I used. It didn't come out as glossy as if I had bought them pre-painted or spray painted them but I am happy with the finish.
Here is a link to the site. I bought the piano black emblem kit (comes with two cans, some pre-dip spray and a microfiber towel). It is not compatible with plastidip so you would have to peel that off first.
Finally got the Megan Racing FSTB installed that I got off of Mark last Fall! Thank you again!
Because I have the GT which does not have an OEM FSTB, I had to buy and install the OEM cowl bracket. While I had the cowl off, I replaced the weather stripping which was ripped and cleaned out the drain on the PS. It wasn't too bad but there were a couple of leaves in there.
Overall the swap wasn't hard. Just don't drop the last mounting bolt down into the engine bay! I used some painter's tape to mark the bottom edge of the windshield wipers to make installing them in the same spot easier.
The OEM cowl bracket kit came also came with two strut tower plates. I wasn't going to use them as I thought they were the same as what was on the car. Upon closer look they were different as they each had two extra studs for mounting the FSTB bracket to them as well as a mounting point for the sound tube. My best guess is they were different as I have the AT. While I had the old ones off, I took a wet towel and wiped the area underneath and around them the best that I could. Proud of me Mark?
Hoping to join the local club on a run this weekend so I can give it a good try-out.
For those interested, here are the differences between the strut tower plates.