CTt3P5

CTt3P5

Moderator Contributor
TAD From Lehigh Valley PA
Joined
Last seen
Posts
8,569
Media
696
Resources
1
Reactions
752
Points
18

New Activity Postings Media Resources About

    • CTt3P5
      CTt3P5 replied to the thread NB MX-5: Hey, it's Minnie!.
      Lookin' good Chief! The highlighting work looks great!
    • CTt3P5
      CTt3P5 reacted to chiefmg's post in the thread NB MX-5: Hey, it's Minnie! with Like Like.
      After finishing up my household chores, Saturday morning I began the ‘charger install. Started off with this: Then came the removal...
    • CTt3P5
      CTt3P5 reacted to chiefmg's post in the thread NB MX-5: Hey, it's Minnie! with Like Like.
      I've been pressure washing our vinyl fence the past two days (pro tip: don't ever buy one). Have some more to do tomorrow to finish and...
    • CTt3P5
      CTt3P5 replied to the thread NB MX-5: Hey, it's Minnie!.
      Nice progress Chief! When do you hope to have it installed?
    • CTt3P5
      CTt3P5 reacted to chiefmg's post in the thread NB MX-5: Hey, it's Minnie! with Like Like.
      Painted another coat on the outlet mani highlight after covering up where I got it outside the lines, so to speak. Cleaned up various...
    • CTt3P5
      CTt3P5 reacted to chiefmg's post in the thread NB MX-5: Hey, it's Minnie! with Like Like.
      Gasket was cut. I cleaned up the outlet manifold and spray painted it so it didn’t look scruffy after getting rid of some build-up where...
    • CTt3P5
      CTt3P5 reacted to chiefmg's post in the thread NB MX-5: Hey, it's Minnie! with Like Like.
      I found out as soon as I started that the outlet manifold gasket was going to be a PITA. The genius who had put it on decided to use...
    • CTt3P5
      CTt3P5 reacted to chiefmg's post in the thread NB MX-5: Hey, it's Minnie! with Like Like.
      Well I’ve been busy as noted above, but there were more things that cropped up that held up this project. Finally was able to get back...
    • CTt3P5
      CTt3P5 replied to the thread What goes here?.
      You're welcome @Sublimer677. I'd replace it as water damage would be inevitable at some point, most likely rust.
    • CTt3P5
      CTt3P5 replied to the thread What goes here?.
      The part you are looking for is this molding cap. You are correct, it does not screw in, it slides into place. It covers/protects the...
    • CTt3P5
      CTt3P5 replied to the thread Too small for me.
      Well, you can't go wrong with the CX-5 either @GrampaSlade. Zoom-Zoom That's ok @sm1ke, just an excuse to go back to the dealer so you...
    • CTt3P5
      CTt3P5 reacted to N7turbo's post in the thread Too small for me with Like Like.
      Yeah, when getting out, you're turning around and stepping towards the back of the car at a 45° angle. At least that is how it works for me.
    • CTt3P5
      CTt3P5 reacted to sm1ke's post in the thread Too small for me with Haha Haha.
      I should have tried it out when I was at the dealership yesterday. One of the YouTube automotive content creators had a little joke...
    • CTt3P5
      CTt3P5 reacted to chiefmg's post in the thread NB MX-5: Hey, it's Minnie! with Like Like.
      Which problem? Because there was more than one in there. ;) Well it’s taken me a little longer than planned to dive into this, due to...
    • CTt3P5
      CTt3P5 replied to the thread Too small for me.
      There is a science to it, getting into the Miata not the little red and yellow plastic push car. ;) I suggest going back to the dealer...
    Show older items
  • Loading…
  • Loading…
  • Loading…
  • Loading…

Mazdas247 Stats

Threads
315,951
Posts
4,608,299
Members
146,182
Newest Member
Dakotida

New Posts

Top Resources

Back