(yes) that is correct sir.
emblem removal
- Thread starter SwampAss
- Start date
(yes) that is correct sir.
MS3_Kendall
Member
- :
- 2007 Mazdaspeed 3
Yea.. $250.00, a little to expensive for a mod that does not give u HP. I rather stick to my black eblems and spend the $250.00 in mods for HP gains. I like the look though. Very nice.
mazdaspeedster3
Member
- :
- Mazdaspeed3. 2008
I have seen a black MS3 with blacked out emblems, it is nice. You can buy them black as well on the net. I just pried mine off and painted them. THe front is clips like posted above, pops out though. THe rear is taped with guide pegs. Easy enough and the adhesive came off with my finger nails.
But what if you're like me and already have every available performance mod? (silly)
MS3_Kendall
Member
- :
- 2007 Mazdaspeed 3
Well, then maybe you can spend that type of money for looks.
Wagonbacker9
Member
- :
- 2004 'Hoe
or maybe you should start lookin into some custom work. enough is NEVER enough.
then its time to sell off some parts (to me) and then buy them new (again)
AutoXRacer
Member
I was thinking to replace the rear emblem with a M-winged Mazda decal.
It should save me some weight off the vehicle to increase acceleration... (burnout)
It should save me some weight off the vehicle to increase acceleration... (burnout)
SuperStretch18
Member
- :
- '07 CX-7 Sport, Black on Black; '04 Mazda3s
I thought the same thing, but I've since blacked out my CX-7 and it looks pretty good IMHO:
well would you rater buy a new hatch and get that painted or fix your old one and get that repaired/repainted for pennies on the dollar?.. because thats the decision i had to make after my garage door fell on my hatch.
MS3_Kendall
Member
- :
- 2007 Mazdaspeed 3
Yea, but ur talking about and accident that happened. I am talking about doing a cosmetic mod because u wanted too for $250.00. You in the other hand had a reason, to fix that dent on ur hatch door. I would do the same (spend the money) if my hatch had a nasty dent, but I would not pay $250.00 to cover up to holes and paint that small section to make it look clean.
MS3_Kendall
Member
- :
- 2007 Mazdaspeed 3
iBoost, u have the gauge pod pillar set up in ur MS3?
weak sauce, i need some new goodies
i have a center dash pod, yes.
mazdaspeedster3
Member
- :
- Mazdaspeed3. 2008
Superstretch18, do you own a MS3 and a CX-7?
MS3_Kendall
Member
- :
- 2007 Mazdaspeed 3
Oh OK, nevermind. I thought u had the pillar set up. Someone had mentioned ur screename when I was asking who had the setup.
x SpEeD 3 x
Member
- :
- Mazdaspeed 3
alright.. i'll post my s*** =]
sorry but this is the only picture i have on my computer right now... just ignore me. lolz
i want mine like this...i like it
