I couldn't sleep last night so I sat down and went through a Crutchfield to design a total system, with just crutchfield parts for under $1000 that I would buy If I was just starting out. Well its a little more then 1000 but I think it would do damn well.
Deck: Kenwood KDC-4019
- 3 pre outs and Sirus capable.
Front Speaker: Infinity Reference 5752cf
Rear Speakers: Infinity Reference 6952i, I have a MP3, adjust to 6 1/2 reference speakers for the P5
Sub: Alpine SW-1241 12" type S
Box: 1.25 cu ft 12" Q-logic box
Amp: Kenwood KAC-749S 4 channel, front channel to front speakers and rear channel bridged to sub
Wiring: 4 Guage street wires wiring kit
RCAs: 2 sets Zero noise 2 16 ft
All this came to $1015
For the bass hungry a later upgrade could be
another SW-1241 Type S 12"
dual 12" Q-logic box
another set of 16 foot rcas
10 ft of 8 guauge power and ground wire
An Alpine MRD-300 for the subs at a 2 ohm load and the rear chanels of the kenwood go to the rear speakers.
This will cost about $675
For the SQ minded a good upgrade would be:
Front speakers: A pair of infinity kappa 5 1/4 components which will fit in any 5x7 opening
60 ft of speaker wire to run into the doors
Sub amp: Kenwood KAC-729S for the sub
the 749 would be bridged to the front speakers only giving each component set 120 watts
Rear speaker ould be run off the deck.
This costs about $500
Enjoy
Deck: Kenwood KDC-4019
- 3 pre outs and Sirus capable.
Front Speaker: Infinity Reference 5752cf
Rear Speakers: Infinity Reference 6952i, I have a MP3, adjust to 6 1/2 reference speakers for the P5
Sub: Alpine SW-1241 12" type S
Box: 1.25 cu ft 12" Q-logic box
Amp: Kenwood KAC-749S 4 channel, front channel to front speakers and rear channel bridged to sub
Wiring: 4 Guage street wires wiring kit
RCAs: 2 sets Zero noise 2 16 ft
All this came to $1015
For the bass hungry a later upgrade could be
another SW-1241 Type S 12"
dual 12" Q-logic box
another set of 16 foot rcas
10 ft of 8 guauge power and ground wire
An Alpine MRD-300 for the subs at a 2 ohm load and the rear chanels of the kenwood go to the rear speakers.
This will cost about $675
For the SQ minded a good upgrade would be:
Front speakers: A pair of infinity kappa 5 1/4 components which will fit in any 5x7 opening
60 ft of speaker wire to run into the doors
Sub amp: Kenwood KAC-729S for the sub
the 749 would be bridged to the front speakers only giving each component set 120 watts
Rear speaker ould be run off the deck.
This costs about $500
Enjoy