What have you done to your P5 today?
- Thread starter Tg5
- Start date
- :
- '13 CWP MS3 & '16 Mazda6 GT
uninstall the old one, install the new one.
- :
- '13 CWP MS3 & '16 Mazda6 GT
- :
- '13 CWP MS3 & '16 Mazda6 GT
psssssh, sure 
- :
- 2016 GT ST 47A
Where in MN....I lived in Rochester for about 3yrs.
Seach my young padawan
http://www.mazdas247.com/forum/showpost.php?p=456400&postcount=47
This is what I used....10 minutes on my lunch break in the parking lot at work.
(rlaugh)
Rockin03mp5
Member
- :
- '13 Mazda3 / '13 Edge / Your Mom
(uhm)
Rockin03mp5
Member
- :
- '13 Mazda3 / '13 Edge / Your Mom
- :
- 2006 Infiniti M
my dads family lives in cason/hayfield. like 20 min from rochester
- :
- 2016 GT ST 47A
Damn Bemidji...so how did you like living in Canada? Did a lot of fishing with my friend and his fam along the MS river, mostly in the Red Wing area.
Small world, eh?
Rockin03mp5
Member
- :
- '13 Mazda3 / '13 Edge / Your Mom
haha
eh
(i dont even talk like that)
it was cold, long winters
and the summers were hot and muggy and short
bemidji kinda sucked
duluth is a great city, but it is also going downhill
at least up around duluth there are some fun roads to drive on
in southern mn, there are very few turns (unless you are by the rivers)
eh
(i dont even talk like that)
it was cold, long winters
and the summers were hot and muggy and short
bemidji kinda sucked
duluth is a great city, but it is also going downhill
at least up around duluth there are some fun roads to drive on
in southern mn, there are very few turns (unless you are by the rivers)
Take out 3 screws that hold cover over the switch, separate the two halfs.
2 screws hold the switch in, unplug the wire harness, remove old switch , put new switch in it's place plug in wire harness, replace the cover, and enjoy variable intermittent wipers. Shouldn't take more than 20 minutes.
http://www.mazdas247.com/forum/showthread.php?t=11300&highlight=replacing+wiper+switch&page=4 post 47
Pat,
Last edited:
Best key chain flashlight ever...?Just rec'd new foglights
3000k hid kits for em ship today
(ugh)
finished installing the sts shifter thanks to boostdprotegelx' input. what a pain in the ass. it was an overall easy install...just hard cuz i have a bad jack and couldnt get the car up very high. so i had my chest literally on the car underneath it. those damn washers that have to go on were the hardest part of the re instasll...so tiny and kept falling out. but finally it is done and over with.
^^^ TWM is definitely ftw! I've had mine now for over three years and it's still going strong with no problems. I'm actually looking into getting on of their new engraved shift knobs now. That and a new boot because my old one is yellowed and cracked 
kudakev615
Member
- :
- pro5
shifter looks great now please clean out the interior ASAP!?!?! and after seeing that "chingy" cd on the floor board, it reminds of that lebron james insuranace company commercial. haha
never seen the commercial. and yes it needs to be cleaned. found those cds behind the console when i removed it. it will be cleaned soon. but as much as i drive this damn thing around it will always look like that. i drive a good 400 miles a week or more if i had to guesstimate it. this is my breakroom half the time im at work. id rather see the dirty inside than have all the rust i do on the outside lol.
