getting closer (carputer setup)
- Thread starter Dexter
- Start date
ELEmental59437
Member
- :
- 2002 P5, 1978 F250
Dexter said:
Why didnt you just do it the other way? I dont suppose you care as much as I do about keeping things so that the car can go back to stock easily.. No permanent mod's for me
DevilsSi1481
Member
- :
- 1999 Honda Civic Si
i agree with u Dexter about the permanent mods on my car as well. wow that thing is moving along nicely, cant wait to see it done.
DevilsSi1481
Member
- :
- 1999 Honda Civic Si
damn sux, i hope u can fix it since its so close to being done.
traitorhound
powered by FLIP
Dexter said:
did you have a air bubble trapped there? if that's it. . that could be the problem and you have to sand it all down and start that section again . .....it took me like 3 days to get the bondo right
ELEmental59437
Member
- :
- 2002 P5, 1978 F250
traitorhound said:
Thats possible, I am sure that I dont have any because I put mine on in thin layers. What you could do is sand it down a little bit and get some fiber glass resin and put 2-3 coats over the bondo and sand it down. Thats what someone suggested to me to do and is what I would do if I ever did this project again. Mine hasnt cracked so I should be ok. Hope this helps.
-Ahmad
traitorhound
powered by FLIP
yea. . thin layers is good.. .. and i really didn't even use that much bondo in mine
i ended up sanding the left side down again and redid the bondo, but for some reason it looks like it will crack again. like right at the edge where the LCD frame meets the dash trim peice. hrm i will see how it looks when i get home
starting over sucks balls!
starting over sucks balls!
Last edited:
- :
- '16 CX-9 GT
hmmm it will work this time i command it too!!
