wiseco ring gap specs?

[95blkprobe]

I am now assembling my motor and I can't find wisecos recommended ring gaps anywhere. I measured them straight out of the box and they are on the top side of oem specs. will this be fine? I'm running .020" over in case if the wiseco recommended gaps are different. Also this motor will be fed quite a bit of boost, probably about 15 ish daily and 20+ all out of a holset hy35

 

[CircuitRacer]

Have u contacted them directly yet? Wiseco needs to be contacted since ur going to be boosted and it will create more thermal expansion. But the top end of the oem spec should be right around where you'll need to be.

 

[95blkprobe]

They are closed today. Im planning on finishing the motor tonight after work

 

[MALESKIMP3]

So just curious what did you end up gaping them?

 

[95blkprobe]

here you go! you will have to decide what you are doing with your motor such as high boost or low boost. you will take the number they give you from a chart and multiply it by your bore which stock is 83mm, .20 over is 83.5, and .40 over is 84mm. also pay close attention to the oil ring gap as well as where to position the the ring ends.
http://www.wiseco.com/PDFs/Manuals/RingEndGap.pdf