Progress bushing remplacement

[Darkjocker]

Is there a better replacement than Progress sway bar bushing ?

(22 mm)

Thank in advance !

(freak)

 

[mx-p5]

i reused my stock bushings....you mean where it attaches to the car? Or where it attaches to the endlinks?

 

[Darkjocker]

i reused my stock bushings....you mean where it attaches to the car? Or where it attaches to the endlinks?

The ones that attache to the car on the "U" bracket, on the crossmember.

I see http://www.energysuspension.com/ but i'm lost, i need the part number

 

[mx-p5]

yeah, i just swapped over my stock bushing into that

 

[25FConv]

yeah, i just swapped over my stock bushing into that

+1 I also used the u-brackets because they were serviceable. I just bent it in the same shape as the stock brackets..........now those bushing are grease-able but i recomment using white lithium grease......the same kind that comes with the set.

 

[Darkjocker]

My sway bar progress is already install since 2 years...

I need a bushing replacement !

 

[br289165]

Whats wrong with the 22mm Progress bushings?

My sway bar progress is already install since 2 years...

I need a bushing replacement !

 

[Darkjocker]

klunk klunk klunk....

bushing dead ...

 

[Darkjocker]

anybody ??

 

[br289165]

Hmmm.

klunk klunk klunk....

bushing dead ...

 

[GNO]

The ones that attache to the car on the "U" bracket, on the crossmember.

I see http://www.energysuspension.com/ but i'm lost, i need the part number

I installed Energy Suspension P/N 9.5158R today. It's the 7/8" Greasable Sway Bar Bushing Set. I modified the brackets a bit in order to make it fit. I used a vice to straighten the legs of the bracket a little. For one leg for each side, I completely straightened and rebent about a 1/4" closer to the end. The Energy Suspension bushings are quite a bit larger than the stockers, so using the stock bracket would require trimming the bushing

My endlinks are shot as well, so there's still a clunk.