Just got the dyno done on my ms3 Today

[fastguy]

300whp isnt that hard on these cars really. all you have to do is get an intake and full tbe and then reflash it with cobb ap to stage 2 maps and youll b at about 296whp then with some other little mods such ass spark plugs and a turbo inlet pipe youll b over 300whp... and then fmic almost 320.. on stock internals and stock turbo

 

[aaronc7]

Your numbers seem good. All you have for power is an intake.

As for your 300 whp remark. . . . not possible. You can't break 300 whp safely unless you upgrade the turbo. With full bolt ons and stock turbo you can prob get around 280ish with a good tune.

fail. intake, DP, FMIC, AP should give you around 300whp. Only mods I have over that are turbo inlet, CBE and meth (not big power adders) and I did 320

 

[Circle9]

Good numbers, but the OP ran on a Mustang dyno, which is know to give lower numbers on average, where as you did a dynojet, which give higher numbers usually!

Edit: Just read up on different types of dynos, Dynojet on average will produce 15% higher numbers than a Mustang dyno.