Header Length Software

[yeloprofan]

Does anyone know of what software you would use to calculate the length of your header tubes? I am looking at building a set and want to do a good job.

Where can you get it, whats it called, how much, etc. Any help would be appreciated.

 

[Gen1GT]

Does anyone know of what software you would use to calculate the length of your header tubes? I am looking at building a set and want to do a good job.

Where can you get it, whats it called, how much, etc. Any help would be appreciated.

Try these guys. http://www.burnsstainless.com/Xdesign/xdesign.html

And this should help

http://www.headerdesign.com/extras/design.asp

 

[akhilleus]

hey gen1gt, how long are your primaries? 36" right. I think the obx i am getting is close to 30" i will measure it. Also keep getting results for the dyno page.
sry about the threadjack.

 

[Gen1GT]

hey gen1gt, how long are your primaries? 36" right. I think the obx i am getting is close to 30" i will measure it. Also keep getting results for the dyno page.
sry about the threadjack.

My headers aren't made yet, but ya, my specs are going to be 36" primaries 1 3/4" diameter, into a 10" by 3" collector tapering to a 2.5" end. It's my next mod, and hopefully they'll be done soon. I've got some front end damage with my car to take care of, then that's a priority. I'll definitely be dynoing them, I dyno all my mods. I'm going to be doing some wideband tuning this time around too, to see if we can play around with a/f with my Airflow Meter....