-
-
Nnegusm replied to the thread Steering rack.Wheel stud, you just whack it out and hammer in a new one. I did 2 on my 2008 Mazda 3. I got them from Autozone, had to sand the...
-
Nnegusm replied to the thread 2008 Mazda5 transmission problem...Any ideas?.OK, so you don't have a clutch. You have clutch packs. 2 entirely different things. You can't fix it unless you replace the...
-
NI had this code also for close to a year and here's what worked for me. I took this particular EVAP hose with the FTP sensor on it...
-
Nnegusm replied to the thread Another New Mazda5 Owner with questions.I buy the FSM PDFs on ebay. It's worth risking the $15. I haven't been scammed yet and the documents have been invaluable and have...
-
Nnegusm replied to the thread P0715 and P0720 codes with no fix…Help!.Year car? Engine? I assume it's an automatic? For my car, the 2.3L for 2008, the Input Speed Sensor appears to connect to the PCM...
-
Nnegusm replied to the thread 2008 Mazda5 transmission problem...Any ideas?.The old models used gear oil...like 1970's or earlier. At some point they mostly switched to ATF. Now I think it's hit or miss. So...
-
Nnegusm replied to the thread IamFODI's 2012 Mazda5 6MT: Intro, plans, questions, and build.Make sure you put the battery cover on. Or, when your weatherstripping fails at the cowl, which it will, rain will get under the...
-
Nnegusm replied to the thread 2008 Mazda5 transmission problem...Any ideas?.Most Manual Transmissions take ATF...but it does depend on the manufacturer. It's been that way since the 1980's.
-
Nnegusm replied to the thread 2011 Mazda3 window failure one by one....Sounds like wiring or a motor to me.
-
Nnegusm reacted to Jack Rabbit's post in the thread 2004~2008 Mazda3 acceleration problems with
Like.
I'm a DIY myself but go to my local mechanic if i can't pinpoint the problem. It could be anything from bad/clogged sensor(s), worn... -
Nnegusm replied to the thread 2004~2008 Mazda3 acceleration problems.Is it not accelerating or not shifting? I thought a bad TCM would exhibit erratic shifting or lack of shifting. Once in a gear...
-
Nnegusm replied to the thread Which sway bar bushings should I get? Please help.How many miles on the struts? If you have the original struts and over 100k miles...they are the cause of your clunking. Had clunking...
-
Nnegusm replied to the thread 2004~2008 Mazda3 acceleration problems.Could be a weak fuel pump. A car that runs fine until you accelerate is often a Throttle Body issue or a fuel pump.
-
Nnegusm replied to the thread Battery light at redline (Mazda5). Belt?.Voltage regulator in the alternator is probably cutting out due to too many RPMs. Or belt is slipping.
-
Nnegusm replied to the thread 2010 Mazda3 blower issue.Electrical OEM parts are always better. But it sounds like you have a short somewhere. So yeah, if you can, test the motor.
-
-
Loading…
-
Loading…
-
Loading…
