CDFP Fuel pump feed line

[COBRA9343]

Hello,


Installed my Autotech HPFP internals today, and all went well except for re installing the pump itself. I feel ridiculous for not being able to re install it after I took it apart. The 3 external torx went in fine, but I cannot seem to get the feed line to the bottom of the pump to seat properly. Ive tried tightening that first then torquing the torx one by one, slowly and carefully. When I turn the ignition on to prime the pump fuel shoots out from just below the nut that fastens the pump to the line. It is not cross threaded (as far as I know) just wondering if anyone else had run into a similiar issue. Any help is appreciated. I can post pics if needed. Thanks

 

[COBRA9343]

Found the issue, when it wasnt threading properly the very end of the nut cross threaded just hair, but enough to cause it to not tighten now that it is lined up. Does anyone have an exploded view of the fuel pump/fuel lines, or know of any easy way to remove the feed line? I have to replace the nut but cannot seem to find an easy way to do so. Thanks again.