Amp good enough

[kubebot]

Don't have all the components in yet. So far just the HU, amp & subs.

HU=Pioneer DEH-P6900UB
Fronts=Polk Audio MOMO MMC6500 125 Watt component (14awg wires)
Rears=Stock (for now, possible Polk momo coax)
Subs=2 Image Dynamic ID10D2 V.2 dual 2 ohm in a dual enclosure (not chambered but will try to add a chamber wall)
Amp=Alpine MRP F356 4+1/4/2 channel (refer to attached for specs)

The amp runs hot right now(in trunk) I'm concerned about hooking up my entire system to it. I know it's ghetto looking, but I'm lacking funds at the moment. Any suggestions would be much appreciated. Never mind the sloppy cable job for now.

 

[strytnyne]

not sure if thats enough for those id's

 

[iredremix]

wish i could help but im curious to know cuz i want a setup like that

 

[kubebot]

The subs are wired like this to the box

from the box to the amp.....yes I do plan on getting better wires once I get better termination outlets for the box

 

[strytnyne]

what are the specs for the amp and the subs?

 

[kubebot]

check the attatchments in the 1st post I put up.

 

[kubebot]

A friend of mine is offering me a PG 5-channel for a cheap price. What if I used this amp?
http://www.techronics.com/index.cfm?fuseaction=product.display&Product_ID=1507

 

[El Ropo]

A friend of mine is offering me a PG 5-channel for a cheap price. What if I used this amp?
http://www.techronics.com/index.cfm?fuseaction=product.display&Product_ID=1507

Still not enough power for those subs. If you only had one sub, it would be adequate.