GP Light Weight Protege pulleys

Status
Not open for further replies.
i'm so exited......i just can't hide it......i know i know i know i know....i know i want it!!!!!
 
do we have to get new belts for any of them? im getting a shop to do it so... yea. but this is awesome.... im getting excited... i have to buy one!
 
The pullies are the same size as the stock ones. so if your belts are in good condition you can reuse them. but unless you replaced them recently and you can spare the cash i recommend you buy new belts since they have to come off anyway.
 
do we have to get new belts for any of them? im getting a shop to do it so... yea. but this is awesome.... im getting excited... i have to buy one!

No, you do not. The pulleys are stock size and will use stock size belts. So, if your belts are good then you will be fine.
The pulleys are in stock.
 
Anybody have any belt squealing issues? Mostly with the rear one that goes to the Alt.
 
So who is the lucky guy who is going to be the first to have this to get a dyno on the crank pulley?
 
Anybody have any belt squealing issues? Mostly with the rear one that goes to the Alt.
I had to tighten up both belts a little after initial install of wp,ps & alt pulleys. No, not new belts. Just didn't wanna overtighten, would rather have them squeal a little then adj until quiet. No problems afterwards. If you park outside in damp or cold then likelihood of noise is probably a little greater.
 
OK this is awesome news that I have not yet seen advertised.
ProtegeGarage is now carrying these! (thumb) (yippy)

Everyone should write a review for the product at PG...
 
Anybody have any belt squealing issues? Mostly with the rear one that goes to the Alt.

I did after about 20 miles or so, but I replaced the belts at the same time. After 20 miles, they loosened up a little, I snugged down the tensioner another few turns, and it's been dead silent for the last 1.5k.
 
Once I buy one of your crank pulley, I'll throw up some reviews on PG. I should do so for lots of the parts I've used, probably. =) Any idea how long until you guys get the crank pulley listed up there, on ProtegeGarage? And is the first page still accurate, that you have three left? If so, I'll PayPal you for it in a little bit, here.
 
The crank pulleys began shipping on Friday. I was only able to get a few out. It takes a lot of time to brouch the center and assemble it. So I still have 16 to get out the door. They will all be out this week. It takes more time than I first though to finish them, however, they are headed out the door.

The first page is not correct. The crank pulleys are out of stock. I will be making more in the coming week.
 
LOL.. I know you want caps right now. But I can't. When the crank pulleys are all out the door I will do those. I don't have enough time in the day right now as it is.
All this crank pulley talk makes me cranky. LOL. No, really, good to see you know I'm just kidding with ya. I fully realize time contraints, production issues & the like. Hell, if I was anywhere near I'd burn some free time helpin out if need be. Pulley review added to PG. Keep up the good work, it is appreciated.
 
Status
Not open for further replies.

New Threads and Articles

Back