cold air for 2005 Mazda3 2.3

:
2005 Mazda 3 2.3
hey I'm new to this whole deal so excuse my stupidity. I was wondering if it would be better for me to use a cold air intake or a short ram induction. so if anyone could help me out I'd greatly appreciate it
 
i was under the impression that short ram air produces more power overall but is not very helpful with fuel efficiency.. Is this true?
 
i was under the impression that short ram air produces more power overall but is not very helpful with fuel efficiency.. Is this true?

IMHO: Difference in power gains wont be noticeable... I say that as a OPINION - dont want to start another internet battle... the theory behind the ram air producing more power and less fuel economy lies on the fact its supposed to shove more air into the cylinder -- more air means more fuel to keep the mixture ratio the same... more fuel/air = more power and of course more fuel also means less MPG...

Short ram air intake takes air from a short distance away from engine usually on top which means the air is hot... hot air is less dense.. less dense = less power which means on some intakes the gain in power due to more air is negated by the fact this extra air is less dense...

Cold Air intakes take air from an area away from engine (usually from bottom front of car) which is "cold air" - this cold air is denser than the hot air around the engine bay. Denser air also translates to more power. Nothing comes for free.. by taking air from "lower front" you do get colder air but you also run the risk of hydrolocking your engine(water ingestion into engine through air intake)

IMHO: Both try to do the same thing in slightly different ways... if I lived in wet places like Florida I would stick to short ram air intake and put a heat shield around it... here in California CAI's do just fine (water? what water...)
 
IMHO: Difference in power gains wont be noticeable... I say that as a OPINION - dont want to start another internet battle... the theory behind the ram air producing more power and less fuel economy lies on the fact its supposed to shove more air into the cylinder -- more air means more fuel to keep the mixture ratio the same... more fuel/air = more power and of course more fuel also means less MPG...

Short ram air intake takes air from a short distance away from engine usually on top which means the air is hot... hot air is less dense.. less dense = less power which means on some intakes the gain in power due to more air is negated by the fact this extra air is less dense...

Cold Air intakes take air from an area away from engine (usually from bottom front of car) which is "cold air" - this cold air is denser than the hot air around the engine bay. Denser air also translates to more power. Nothing comes for free.. by taking air from "lower front" you do get colder air but you also run the risk of hydrolocking your engine(water ingestion into engine through air intake)

IMHO: Both try to do the same thing in slightly different ways... if I lived in wet places like Florida I would stick to short ram air intake and put a heat shield around it... here in California CAI's do just fine (water? what water...)

AATTAACCKK!!!!!!! lol just kidding! (wiggle)

What he said. Basically.

I've had both Short Ram Intake(SRI) and Cold Air Intakes (CAI) on my Ford Focus, and the CAI gave me more power, at least from the butt dyno. The Short Ram made my car do the hesitate then go from a 0-60 stomp. Then again, that was in the hot Arizona sun. Here in Cali, it didn't do it as much. It sounds sweet too. Then I bought a used AEM CAI for it, and my car felt a helluva lot more stronger. It could've just been my imagination, but it did pick up a bit faster, and sounded a lot better than the SRI. Then again that was my ford focus.

The CAI I installed on my 05MZ3 sounds almost like an STi, only not(that rumble sound coming from the engine bay). But its all personal preference my guess. If you can afford to go both routes, SRI, and CAI, try it. If not go with what you think will bring more peace of mind in the long run. Hydrolocking in a rainy area? Or not hydrolocking in a rainy area? Let us know what you decide.

-J
 
thanks alot guys. well I live in norcal so rain is very minimal and I've heard that by installing a bypass valve I would greatly reduce the chances of hydrolock. I'm going to go with a cold air intake. I'm thinking I'll order an Injen RD series.. Anybody have any better suggestions?
 
Back