i dont want to make a thread for this butttttttt

[Dr0]

How do I connect my aem uego to my ssafc?


Is it the white or blue wire from the wideband?

And which of the four input wires on the ssafc do i connect it too?

Sorry for this dumb question but I can't find the answer anywhere and I've been putting it off bc I don't want to make a a thread just for this but here goes nothing.

Thanks!

 

[KrayzieFox]

*WHITE* Analog Output
Connects to any auxiliary unit that accepts a 0-5 volt input.

*BLUE* Serial Output
Connects to a RS-232 com port for hyper-terminal data logging.

Connect the white wire from AEM to any of the 4 orange wires on AFC, they're all the same.. just different channels for input. And check the AFC sticky for instructions on how to calibrate the signal in the R4 software. The attached PDF has the corresponding AFRs based on voltage values from 0-5v.

 

[Dr0]

Thanks so much!