Flash...Joe P FPR Removal?

[goonsquad]

I have an appt. at 8:00 tomorrow morning to get the flash

I have a MBC installed as well as the Joe P FPR. I was gonna take out the boost controller but I don't have a little screw to plug up the hole on the air intake from the FPR kit. I don't feel like going to get one. Did anybody leave theirs on? Should I take mine off?

 

[srtchick]

where are you gettin it done @ in NJ ?

 

[goonsquad]

East Coast Mazda in South Wood Ridge NJ. The guy (Antonio) claims if there is a fix he will be able to install it but knows nothing specifically. Basically I'm very skeptical that he'll be able to do it but it can't hurt to try. Also I told him I want my clunk fixed and he said he could do that definitely. He knew about the clunk issue.

 

[Vassago]

I am also interested to know about this. Has anyone run the flash with the FPR installed? I dont like the idea of having a screw stuck in my intake. Maybe its a good excuse to buy the injen.

 

[KyRaceFan]

i attempted to JBweld my hole.. but i didnt wait long enough for it to setup, and couldnt get it to not drip...
I might try again.. but i plan on hard pipes....

For now, just use vacuum caps on the T and elbow fitting, and remove the vacuum line from the elbow to the T