WTB: Cam Position Sensor Plug

[25FConv]

So the Ground wire to my CAm position sensor wire broke at the plug. I need a Cam position sensor plug, if anyone has a wire harness they don't need that plug on. I need it asap. please help.

 

[XoX1de]

camshaft sensor connector

pmed

 

[25FConv]

replied.

 

[dstmsp03]

yours did that too?? i just re soldered mine in there

 

[25FConv]

yours did that too?? i just re soldered mine in there

wasn't even possible for me to......the wire broke right at the plug to prevent water from getting in......no room to solder back.

 

[Borncuban67]

could u tell me where the sensor is located?

 

[SIBalla23]

Did you ever try taking the plug apart. I mean taking the pins out the back from the harness plug, remove damaged wire from pin. Splice the wire and insert into pin,crimp it and install pin back into plug. You would need a hook and pick set to do this. I have repaired many wire and plug harness this way.

 

[25FConv]

could u tell me where the sensor is located?

Its the two wire sensor on the bottom right of the valve cover.

Did you ever try taking the plug apart. I mean taking the pins out the back from the harness plug, remove damaged wire from pin. Splice the wire and insert into pin,crimp it and install pin back into plug. You would need a hook and pick set to do this. I have repaired many wire and plug harness this way.

I actually ended up doing just that.....had my car dyno'd since and put down 289hp and 294ft/lbs at 15psi.

 

[Borncuban67]

Its the two wire sensor on the bottom right of the valve cover.



is this on a mazda 6? or protege?

 

[mzdspeed82]

does anyone know the torque in which we have to tighten the camshaft shims... i dont have a torque wrench,well not yet, but can i just tighten them by hand?
thx in advance