What have you done to your P5 today?

forget what i said about the tails. I am looking at parts for the bike now.

After the TL headlights and a suspension setup, Pro5 mods will be coming to a close
 
That was record time too! Damn, you're getting faster at changing your mind. Hell, I'd even go as far as to say you're approaching Woman!
 
i have a terrible memory. I had just remembered about the parts my buddy told me about lastnight.

And I ALWAYS have ideas. i just don't voice em. You guys would go nuts if i did.
 
CTt3P5 said:
Yeah...considering I had the damn thing in the house yesterday and dried it out with a hair dryer/silica gel pack.

Think my mechanic will overlook it during the inspection? haha
Click to expand...

jeff, what happened to the headlight?
 
Pro5x2 said:
forget what i said about the tails. I am looking at parts for the bike now.

After the TL headlights and a suspension setup, Pro5 mods will be coming to a close
Click to expand...

You are too much Tylor....lol Hey man, it's your money dowhatcahlike. And if the TL headlights and suspension are the last that's a nice way to go.

Reitrof said:
jeff, what happened to the headlight?
Click to expand...

At first I thought it was due to the rubber boot partially popping off from all of the wires/rubber washer stuffed in there for the HID kit. Apparently though, the seal is shot from when they were painted. I did buy this set used off of another member and last winter they gave me no problems.
 
magnumP5 said:
Definitely not 7 inches wide; I guarantee you that. They're either 6 or 6.5 inches wide, I can't remember which. I really want to say stock wheels are 16x6 +50mm with a 5x114.5 or (5x4.5) bolt pattern.
Click to expand...

maybe i'm thinkin of the 17 i have on mine....my bad....i think it is 6"
 
magnumP5 said:
Definitely not 7 inches wide; I guarantee you that. They're either 6 or 6.5 inches wide, I can't remember which. I really want to say stock wheels are 16x6 +50mm with a 5x114.5 or (5x4.5) bolt pattern.
Click to expand...

Actually I just went out in the garage and measured them and from outside edge of the wheel to outside edge of the wheel(tire not included) they are 7-1/8" wide. That might not be where the width of a wheel is measure though, not sure
 
Considering that the stock tire width measurement is 195 (IIRC), I would also say that stock rims are 6". I think you should be measureing the inside of the bead, that should get you closer to 6".
 
Breeegz said:
Considering that the stock tire width measurement is 195 (IIRC), I would also say that stock rims are 6". I think you should be measureing the inside of the bead, that should get you closer to 6".
Click to expand...

Yah, I was measuring from the outside of the bead
 
Did the mazda alarm upgrade install yesterday without issue, works fine. Guess we'll see how long according to reports.
 
Please log in or register to reply here.

New Posts and Comments

B
Creaking/Groaning Noise during low speed braking (2023 CX5)
Replies
4
Views
81
bizkitgto
B
K
    • Like
  • Sticky
What have you done to your CX-5 today?
478 479 480
Replies
10K
Views
2M
yrwei52
yrwei52
W
Vague Transmission Oil Change Recs Vs Common Sense & Reality
2
Replies
28
Views
608
Lazy2.5
L
R
Anyone bothered by the poor front LED lights?
Replies
19
Views
735
hsdejong
hsdejong
Z
Mazda3 doesn't seem to want to start immediately?
Replies
19
Views
342
wlong01
W
A
  • Question Question
Loc/Unlock Signal Wire
Replies
0
Views
29
Arrow68
A
View more…

New Threads and Articles

Back