What have you done to your MSP today?
- Thread starter baconbitz
- Start date
- :
- '13 CWP MS3 & '16 Mazda6 GT
thread link?
- :
- '13 CWP MS3 & '16 Mazda6 GT
whats the estimated cost so far on that?
Polished her newly acquired coooooler...
damn i'm jealous...
lol...o yea? well when turbolifes done with his cores we'll be the exclusive KO Perrin FMIC club HA!
MSP2003.5_Nick
Member
- :
- 2003.5 Mazdaspeed Protege - Dark Silver
Well I've been bored this week so i decided to do a bit of wire tuckin. completely relocated the engine bay fuse box inside the car under the steering wheel. It turned out to be a lot more work than i thought. had to take the fender off, cut and extend most of the connections (solder and shrink wrap dont worry!) but i must say the end product is very pleasing to the eye to get that plastic wire b**** out of the engine bay 
Only porblem was I forgot to hook the alternator ground back up so the battery was hatin life on the test drive. Got down to 10 volts before I realized and peeled home. But its all good now!!!
Only porblem was I forgot to hook the alternator ground back up so the battery was hatin life on the test drive. Got down to 10 volts before I realized and peeled home. But its all good now!!!
MSP2003.5_Nick
Member
- :
- 2003.5 Mazdaspeed Protege - Dark Silver
AHH lol ok, I only have my cell phone camera at the moment though. But since you guys are apparently gonna ban me without pics then brb lol.
MSP2003.5_Nick
Member
- :
- 2003.5 Mazdaspeed Protege - Dark Silver
This is what it looked like before.
This is after it, still have to do a lit of wire loom and zip tying at the back though.
The wire used to come through that hole now you see it goes under instead.
This is inside, again needs to be tied back more, though it is completely out of the way of the clutch.
Its not too jalopy I hope
At least it all works!!
EDIT: just in case you were wondering the battery has already been relocated to the trunk a couple months ago.
This is after it, still have to do a lit of wire loom and zip tying at the back though.
The wire used to come through that hole now you see it goes under instead.
This is inside, again needs to be tied back more, though it is completely out of the way of the clutch.
Its not too jalopy I hope
At least it all works!!
EDIT: just in case you were wondering the battery has already been relocated to the trunk a couple months ago.
Last edited:
blkonblkMSP
Member
- :
- Mazdaspeed Protege
Do you get any compressor surge AKA(turkey) with that set up?
