it sounded like his bank let him refinance his car loan?
maybe free'd up quite a bit of monthly wiggle room, so he is spending it in a lump sum i suppose?
What have you done to your Mazda6 today?
- Thread starter Antoine
- Start date
it sounded like his bank let him refinance his car loan?
maybe free'd up quite a bit of monthly wiggle room, so he is spending it in a lump sum i suppose?
- :
- MazdaSpeed 6
well thats part of it.. and i had some cash saved up for the RX-7 too..
my goal is to be in the 12.2-12.6 range on the 1/4 mile, along with being a show car, and also the Signature Shop Car for the new business..
the turbo i could get out of that list could always change..
Last edited:
- :
- MazdaSpeed 6
im not 100% confident i can do a 100% Tuck.. i know i can do alot of it.. and all the Lines going to the IM can be re routed too.. theres really no way of getting around the coil pack wires though.. we'll see..
- :
- MazdaSpeed 6
which one do you have??
Yeah I was trying to figure out how exactly that was going to work... I'm used to seeing Supra's with a full tuck and it just makes the engine bay look so clean... washer fluid, battery, and all that relocated to the truck so its just engine, turbo, and piping. SOOO CLEAN.
Speaking of Supra's, probably going on a cruise with my Supra friend today
He needs some help replacing his valve cover seals, then gonna cruise after. Ill see if I can snaps some picsamilliems6
Member
- :
- MazdaSpeed6
re installed my low beam bulbs last nite, didnt turn out as good as i wanted it to be.
and to add on to that, my check engine light came on today, gunna find out in a couple of hours what the code is....hoping its nothing too serious since the car felt fine when i drove it. ef em el
and to add on to that, my check engine light came on today, gunna find out in a couple of hours what the code is....hoping its nothing too serious since the car felt fine when i drove it. ef em el
Suspect987
Member
- :
- '06 Mazda Speed6
Finally installed the SLS Test Pipe that has been sitting in my closet for a few months while I was out of town. They quality of the Stainless Steel pipe is great. My only knock was on the hardware they shipped, not one lock washer or lock nut. I replaced the nuts with lock nuts and moved on.
amilliems6
Member
- :
- MazdaSpeed6
I kno this isnt a "ask a question" thread but since we dont have a shout/chat box and it would be pointless to start a new one.... so i wanted to ask the trunk cargo net owners/non owners to see if anyone on here knows where i can get the screws that are located in the trunk?
The screws that im talkin about are on the bottom right when you open the trunk... theres two on both sides and they're basically there to hold the trunk cargo net.
My problem is.... two of them broke.. so i either need to replace them or just sell the cargo net.
once again, my bad for thread jack.
The screws that im talkin about are on the bottom right when you open the trunk... theres two on both sides and they're basically there to hold the trunk cargo net.
My problem is.... two of them broke.. so i either need to replace them or just sell the cargo net.
once again, my bad for thread jack.
I'll buy the cargo net... I've always needed/wanted one.
- :
- 2011 Mustang GT
Got the Kumhos installed. So far the car is so much quieter than with the Paradas and drives great. Only put about 5 miles on them since I got them installed.
amilliems6
Member
- :
- MazdaSpeed6
Well let me just say that the trunk cargo net is pretty handy but if i cant find the screws then its yours. Pm me in a couple of days.
Anyone else know where i can get the screws?
I managed to change the oil as well as the transmission fluid. My 3 new center vents came in so I put those in. I love how now the vent actually stays where you put it instead of flopping closed!!
I went to the track tonight and made a couple passes. My best time of the 2 was a 13.1 @ 105.
I went to the track tonight and made a couple passes. My best time of the 2 was a 13.1 @ 105.
- :
- MazdaSpeed 6
mmmmm New Rubber.. Always hard to launch the car with new tires.. but the car looks badass with new tread especially if your lowered..
Well I got some bad news... Ends up I am waiting a couple more weeks for my Cobb AP. Decided to save some extra money before I buy it. But! Instead I ordered my sharkfin antenna, black eyelids, and sls test pipe
You have the Mod Bug!!
Taylor.. almostttttt a 12 second speed6
.. i wonder what mine would run.. most likely the same time. hehe.. im hoping to be 1 second faster then you after the build. (headbang)
Last edited:
block8head
Member
- :
- 06 MS6 black mica GT
Put the SPC ball joints on the car today and went to the chevy dealer traded-in for this:
From this:
To this:
Brought her home today....
Exterior
Interior
(breakn)
From this:
To this:
Brought her home today....
Exterior
Interior
(breakn)
Last edited:
