Trubendz Exhaust(Pics and Video)

Dmack_901

Member
I just my my Trubendz exhaust installed, and it's great. I got a 2.5" stainless, without a cat or resonator(but I'm probably going to put at bullet muffler in or something else down the road). With that setup it cost $300. It will be available in 2.25" and aluminized too.

Visit http://www.Trubendz.com


(<--Edited, turns out it was to the side due to installer-error)

The dyno plot is off. But I think it isn't completely worthless. It shows the new powerband, just lower than it should be, and disporportionately above the stock one. Anyway, I do feel a pretty good gain on the butt dyno. And I'm going to try and get an accurate plot.


5 to 50
reving
 
Last edited:
Yea, I emailed them about that. Mine was a prototype for the sedan, so I'm pretty glad that's the only "problem". It will be fixed.
 
did you have to get any of the pipes expanded when you got the kit? when i bought one from them they didn't make the pipes slide over each other.
 
They expanded them, and they slid over one another just fine. I didn't have any problems getting it on. Overall I had a great experience with them.
 
Dmack_901 said:
They expanded them, and they slid over one another just fine. I didn't have any problems getting it on. Overall I had a great experience with them.
I am sorry, but I am just too immature and thought that sounded hilarious in a sexual way
 
Not bad. I like that the tip isn't WAY HUGE and (rice).

Any idea how much with a hi-flow cat?
 
rum said:
They tend to be under $300.

Ummm... if the system without a cat is $300, how is a system with a hi-flow cat going to be under $300? (scratch)
 
liked the sound when driving but thought the sound when just revvin was like a melon shooter... may be different with a hiflow and/or resonator.... not a bad sound though, perf gains seem a bit much for just an exhaust but with it just bein a straight pipe..?? what other mods do you have...cai/sri.. header...?? etc...
 
LOL, tphskab, you sick sick little boy. ha ha, too good.

It's $300 for stainless. You could probably get aluminized for around $300, or a little more with a cat. For a price on that you get a hold of them( Contact info). About the gains, there's no way it gained that much. After all, it shows 20tq at 2500rpm. I do have an AEM CAI, but I've had that on for months.
 
Last edited:
Dmack_901 said:
I do have an AEM CAI, but I've had that on for months.


just having an intake or an exhaust will show gains, but by having both you usually get more then the two together bc you are letting it breathe more over all... get what i am sayin... by having your base run done with an intake it may show more gains then with a person who is just putting on the exhaust without an intake... but all this is irrelevent (sp) b/c like you said the dyno is messed up....
 

New Threads and Articles

Back