scmp3's build thread:start to...it will never be finished

[funkalicious21]

Sub!!!

 

[SCMP3]

The morimoto monies. The $270 kit.

 

[SCMP3]

Walboro 255 fuel pump ordered from Sam today. Hopefully I can have it in by the time I go to daytona next weekend.

 

[SCMP3]

picked up a full p5 leather interior to swap into the msp for $50......its pretty perfect. ill upload pics later.

and i got my tracking # for my walboro lat night should be here by tuesday

 

[hornsfan10609]

Badass man, the P5 rear seats don't fit in the sedan but the fronts are the same. Don't think the leather skins will fit either because the P5 seats fold differently than the sedans.

 

[95blkprobe]

goodluck with your fuel pump swap. take some pics please. I was going to install a walbro in my p5 but stripped three screws then said **** it

 

[hornsfan10609]

+1 I also plan on a Walbro in the future.

 

[SCMP3]

I'm working it out the front skins are the same. The rear bottom is 2 separate pieces where the msp is one solid piece. I'm curious about the backs of the back seat though

 

[hornsfan10609]

I used to have a P5, the back seats are completely different, top and bottom.

 

[SCMP3]

Ah ok. Well I may figure something out

 

[SCMP3]

dyno video dynoed in at 189hp 181tq


and some pics from the rolex 24 hour le mans mazda corral

 

[dacquesta1]

those are some nice numbers for your setup bro...car is looking good

 

[SCMP3]

thanks. i should be adding something soon that will hopefully get me over 200hp

 

[dacquesta1]

if your going for over 200hp on stock block spend the money for a couple hour dyno tune session (unless your comfortable tuning). i would hate to see your motor go boom. maybe meth injection?

 

[SCMP3]

Id think it will be fine. I'm not uping the boost yet.

 

[super1chow]

Good numbers man, surprised your not over 200 though. With my mods I dyno'd 192//192, up the boost!

 

[SCMP3]

Thanks super. Also can you tell me how you wired in your high beams for the projectors? I still need to wire the high beams in.

 

[super1chow]

You have to buy a relay harness off of retrofit source, since our headlights are h4.
Here's the link:
http://www.theretrofitsource.com/index.php?cPath=28

Ill take a pic of my wiring when I get a chance.

 

[SCMP3]

I'm pretty sure I have said relay harness. Pics of how you wired it yo would be fantastic

 

[Spiced MSP]

nice numbers bro