Running Daylights

[ZoomVT]

So i saw a post on the How-To forum to allow your fogs to run independent of your low beams. The how-to was for the proteges, can anyone post some instructions for the 3? i figured is basically the same but i would like to get the right wires colors and the locations. I am also looking into getting Angel/Demon Eyes and i would like them to work with the fogs

I want this:
-Fog switch functional
-Fogs on with parking lights
-Angel/Demon lights with parking lights
-Fogs on with High Beams

Anyone that can help it would be great.

 

[tsunami]

iirc, there used to be a how to for the independant fog light adaption, and as far as the angel eyes i see no reason why you couldn't wire them up to a normaly open contact with a switch to close it whenever you wanted. that way with the fogs and angel eyes on their own switches you could have any combo of high/low/park you wanted with the fogs and eyes...

 

[TheMAN]

used to?
http://www.msprotege.com/forum/showthread.php?t=107180

 

[ZoomVT]

i just looked at that thread and i woudl ike to prevent messing with the PJB and voiding the warranty. Someone mentioned there was another way to do the foglight mod.
Anyone knows?

 

[TheMAN]

the only other method (which is what most people use) is far from factory looking

 

[tsunami]

just bypass the wires completely from the car and use your own voltage supply with a switch in the dash...if you did it right.. i mean going back and removing the stock wires from their terminals and routed your new wires correctly it wouldn't look to bad.

 

[ZoomVT]

dude that sounds like a lot of work, plus i want it to look stock, no switches in the dash. Im really on the fence about this. i really REALLY want the DDEs but i still have another 25k miles/3.5 years of warranty left. And i dont want to wait.

 

[tsunami]

not that much really, and you could put in a nice small switch over near the dimmer where there are 3-4 empty switch holders... but if you want to be able to use your already exsisting fog switch... i dunno...