Question for those who've done springs

[SloPro5]

When you removed the seatbelt assembly in the rear of your P5, did it use the same bolts as the suspension components or were there two extra bolts piled on top to hold the seat belt assembly down? Anyone who knows please reply quickly as I am getting nervous about the extra bolts. Thanks guys.

 

[ozz]

their is a 17mm bolt to hold the seat belt assembly in place and then theirs two 14 mm nuts under that holding the black seat belt bracket and under that is three 14 mm nuts for the upper strut assembly hope this helps

 

[slamprotege5]

I did not have to remove my rear seat belt assembly, just slid the plastic piece on top forward and layed that over the back seat. The seat belt anchors do not have to removed to get to the strut cover. Good luck figuring that one out.