putting badges back on

[tuOdekcalB]

So I know there are so many thread about taking them off, but how do you guys put them back on. Since the mazdaspeed has no pegs what methods you use to make sure it is centered like before.

 

[TKMS3]

Before you remove it make a square around the emblem with masking tape to mark its position

 

[tuOdekcalB]

yea that's what i was thinking of doing.

 

[Cue]

Just put that grey 3M 2 sided tape on the back and trim it with an exacto knife. It cuts very easily...

 

[tuOdekcalB]

Just put that grey 3M 2 sided tape on the back and trim it with an exacto knife. It cuts very easily...

Yea I know that. was seeing how to get it back on centered. since i def have some type of ocd that if its crooked it will kill me

 

[dizzin9]

with a dry erase marker.

 

[Cue]

Yea I know that. was seeing how to get it back on centered. since i def have some type of ocd that if its crooked it will kill me

Ahh.. I should read more thoroughly... I use masking tape... dry erase; I've never thought of that

 

[Zeya]

Hey I recently painted mine. I tried using the glue on the rear one. It would have been fine, but either the glue or the adhesive cleaner I was using to clean up the smooshed glue was eating away at my top coats! So I had to take it off and paint it again. I'm going to use some moulding tape this time to put it on.

 

[Red08Speed3]

Just put that grey 3M 2 sided tape on the back and trim it with an exacto knife. It cuts very easily...

+1 ^ (burnout)