P0113 and P0660

[VIPMSP]

the other day driving home my new MSP tripped out and the check engine light started blinking on me and it started driving like a blew a coil pack. swapped them out and everything was fine. driving it again today for the first time in a few days and it read codes P0113 and P0660. i did a little research and found that its the VICS solenoid and the intake air temp sensor? what exactly should i do to fix this?

i just swapped over my TurboLife FMIC and piping from my silver MSP (which includes a relocated MAF)...

 

[hornsfan10609]

If the IAT sensor is plugged in then it may have failed, same with the VICS sensor. I would grab a couple from a JY if you can, they are expensive new.

 

[tweety2300]

Vic's solnoid won't actually trip the cel it's probly been like that for awhile, mines been bad for years but I don't run it hard so not worried about replacing it

 

[VIPMSP]

^ def hasn't been like that. didn't happen until my piping/relocated MAF and FMIC were swapped over

 

[hornsfan10609]

The codes could have been stored previously or may have popped up if you unplugged or messed with any of the sensors while the car was running.