need help with fcd asap!

[jestermsp]

ok so here's an interesting question... i just hooked up a joe p fcd and i hit fuel cut worse than ever! any ideas? it didnt come with instructions so maybe i hooked it up wrong but i really dont think so. help asap please!

 

[jestermsp]

Does it matter which wire on the fcd goes 2 the maf signal wire and which goes 2 ground? I have the top red wire tapped into the center green and black wire on the maf plug. And the bottom red wire on a factory ground. My boost signal is t'd off the wastegate line. Again help me! Lol

 

[Earful]

Subbage...since I havent installed mine yet...

 

[fastasmsp]

if you call or email joe he will tell you how it should be hooked up.

 

[fastasmsp]

he told me but it has been to long and i dont remember. but mine works just fine at 10psi

 

[jestermsp]

is he still active on here? i have a fun run tomorrow so i kinda need to fix this today.

 

[y0sky]

Bump because I know someone on here knows exactly how to hook it up. Wish I could help. I never installed one.

 

[fastasmsp]

here is his email tech@joepmbc.com. On the fcd there are two black wire one goes to ground and I think one goes to the green wire on the MAF. I know that the wires does not matter which goes to ground and which goes to the MAF. Here is the link to the instructions http://www.joepmbc.com/fcdinstall.html

 

[jestermsp]

Hey problem solved. Thanks everyone. I switched my vac source from after the boost controller 2 before it and good bye fuel cut. So as an fyi make sure you are directly off the intake mani with nothing before your fcd line.