Getting the car put back together, and am finally at the point to reinstall the driveshafts. I'm starting on the drive side. I go to insert it, and it just won't go in. I haven't beat the crap out of it, but I gave it some pretty solid pushes. Its like I'm pushing against a brick wall.
I've looked at it a couple times, and don't see anything preventing it from going in. What's the trick? I did see the not from the manual to have the gap in the c clip up, but that didn't help either.
I didn't put anything in the trans with the axle out. I read some posts about the spider gears potentially falling out. I'm not going to pretend I know exactly what that means, but their isn't blocking the hole until much deeper, and I'm not getting the shaft in there at all.
I've looked at it a couple times, and don't see anything preventing it from going in. What's the trick? I did see the not from the manual to have the gap in the c clip up, but that didn't help either.
I didn't put anything in the trans with the axle out. I read some posts about the spider gears potentially falling out. I'm not going to pretend I know exactly what that means, but their isn't blocking the hole until much deeper, and I'm not getting the shaft in there at all.