Grounding Cylinder Head Test Results (2024 CX-5 Turbo)

[N7turbo]

Ground wires don't go bad like sensors. They are not wear items.

 

[AL Cx5]

While browsing broadly to learn, I came across grounding kits that are meant to replace factory wires, for the same reasons you replaced functioning sensors. So far the only factory grounding wire that I found to be stand-alone, is the cylinder-to-chassis on the passenger side. It looks thin next to my 6 gauge battery cable. I assume thicker is better. Are there any other factory grounding wires that are easy to replace? Most others seem to diverge from bundle of wires. Thank you!

I was off topic and was hoping to learn more about our engine sensors. When do they start losing calibration before a CEL comes on from an automotive engineer.

Honestly, I have done more than a cursory look for OEM grounds. I see them but don't pay much attention to them. My goal was to do the tried and true extra grounding for better FE. The car had less than 100 miles on it when I installed the grounds, started this post. The community was more critical than interested. I moved on.

After grounding my attention went to improving handling, picking wheels and tires. The suspension install was more involved that other cars I've worked on but got it done.

Next was installing a slight performance tune and we enjoyed the car. We are finishing the next upgraded tune. It's almost a hot rod. Needs another 100 HP and it would be a handful. LOL Honestly, the new power level is just right. Drives like stock until we turn on Sport mode. Then it gets fairly aggressive. FE with this tune is even better than stock or the first tune. The first tune was more FE than stock too.

 

[SparkYellow]

Ground wires don't go bad like sensors. They are not wear items.

Do they age though?

 

[GFrosty]

Do they age though?

Ground wires' copper can corrode (though high-grade wiring that's tinned and wrapped helps). The ring ends can corrode. But I wouldn't think any more so than existing ground wires. I'd call it a "for the life of the car" type part. Unless seeing severe salt-laden air (near coastlines) or if getting wet frequently (ie, hosing down the engine bay), perhaps.

My own 2016 CX-5 doesn't have but light surface discoloration (hardly enough to call it "corrosion) on "ring" ends here and there. Several of the various bolt and screw heads have far more.

 

[AL Cx5]

Ground wires' copper can corrode (though high-grade wiring that's tinned and wrapped helps). The ring ends can corrode. But I wouldn't think any more so than existing ground wires. I'd call it a "for the life of the car" type part. Unless seeing severe salt-laden air (near coastlines) or if getting wet frequently (ie, hosing down the engine bay), perhaps.

X2 on age. If you live in an area that puts chemicals on the roads in the winter, ground connectors can corrod.

Using experience gained from a 20 year old truck. Battery power and grounds corroded under the insulation. I'll always pay extra for an agm battery for this and other reasons.

Guys with older truck is who live up north have way more electrical issues as the grounds and wiring harness corroded. Hard starts, poor FE and electrical gremlins. We always recommend to newbies to clean the ground connectors or better yet replace with a HD set.

I make my ground cables from tinned, fine strand 4 gauge wire, marine grade with water proof shrink wrap and tinned connectors. These should last longer than the car. But audio wire and copper connectors will work fine. Others made the grounds from welding leads.

The finer the strands the better it will ground is my rule.

 

[N7turbo]

Stranded is for sissies. Just use solid wire.

 

[Nevada CX5]

The chassis steel and welds are not great conductors. Thick copper wire has much lower resistance. When connected to well chosen grounding points there can be a benefit.

A obvious grounding point on my 2018 can be found by removing the plastic cover on the engine revealing a factory grounding point near but not on the the throttle body.

 

[SparkYellow]

Thank you ALL especially AL! Being in a warm climate, the wires are probably OK. I have put away the extra cables for now and will focus on driving.