FS - Parting out FSDE

Ofcourse it doesn't run - it's got a hole in the block! But....there's loads of parts on it that can be used still. Entire engine is up for grabs, that includes just about everything else that goes on, or in the engine. I haven't taken the head off yet - but I do believe it's still in great working condition.

auto trans (still works perfectly!)
covers
coilpacks
tb (pending sale)
stock intake boot/filterbox/piping/collector for underhood
valve cover (sold)
OEM exhaust mani/heatshield
OEM muffler (minus hangers)
hoses
belts
oilpan
Plug wires
maf (sold)
Intermediate Shaft (ATX)
primary cooling fan (driver side)


and the parts from the KL that can be reused:
mani's/heatshields


just about everything else that didn't get trashed in the explosion.

Lemme know if any of this interests anyone!

 

[ihone]

you're in luck - the entire engine side of the harness is still uncut under my hood. I just coiled it up for later removal.

10 bucks shipped?

 

[slipkornvayne]

there should be 2 sensors by the passenger side strut tower that are connected to the engine harness if you still have them how much shipped to 07652

 

[ihone]

2 sensors - which 2 sensors? Get a picture and I'll get them. I just don't want to say yes and send the wrong ones.

15$ shipped for 2 connectors though.

 

[slipkornvayne]

there is a lil piece of the engine harness that is seperate from the bulk of it right when it comes through the firewall. the wires come up the firewall and sit between the strut tower and fire wall. i lost the sensors or relays whatever they are

 

[ihone]

Just the connectors, right? Or the sensors also?

2 Connectors - 15$.
2 sensors - 25$.

That's shipping included.

 

[ihone]

bump

 

[95blkprobe]

how much for the knock sensor on the back of the block?

 

[ihone]

knock sensor - $20 + shipping

 

[95blkprobe]

do you have a pic of it?

 

[ihone]

I can grab one when I head out there tonight to replace the blown struts and slot my rear struts for some much-needed neg. camber.

 

[ihone]

heading out to the shop tomorrow to grab pics of requested parts.

I also pulled the parts that have been asked for in the thread thus far -

valve cover
valve cover washers
coilpacks
connectors

 

[ihone]

bump

 

[frankjuda]

hmmm do you think the cylinder head survived the explosion?

 

[Protege_MP3_506]

10 shipped for that harness sounds great man. I'll PM you address and paypal you some money tonight.

 

[slipkornvayne]

you have a pm

 

[ihone]

$10 for the small pigtail with that plug.

The head I'm not sure of. I'm going back out there tomorrow to pull a throttle body and whatever else I get requests for. If you'd like for me to remove it and inspect - I can.

 

[Protege_MP3_506]

yep thats all I need is the little clip just cut up enough where I can connect wires to it. Whats the paypal?

 

[ihone]

Junya1985 - you have PM
Big Lou - you have PM
2088MSP - you have PM

 

[ihone]

Still have parts from this as follows:

PS pump
AC compressor
coilpacks/wires
wiring harness bits (not complete, still on car)
Alternator
head/cams(stock)
various sensors from the engine
crank pulley
full stock intake mani
atx trans

 

[spike94mx6]

How's the crankshaft?