Fog light lens

[BDL]

Alright......a rock (must have been) put a hole in one of my glass fog light lenses. I noticed because water got in there and popped the bulb. I took it to my dealer to get the bulb replaced (not knowing I had a hole in the lens) and they said it would be around $500 to replace ($375 or so for the housing, and $95 in labor). According to the dealer, a replacement lens couldn't be ordered, and the entire light housing needed to be replaced.

Anyone know of a cheaper alternative?

 

[Haltech]

Is this a speed or a reg 3? If a reg 3, there are tons of foglights on ebay you could choose from. If a speed3, youre screwed mate. Speed 3 alternative would be pop both stock fogs out, make them into air ducts for the brakes. Than install aftermarket fogs in the black grill.

 

[BDL]

2007 speed3. Not sure i'm ready for major reconstruction, although I'd consider it rather than giving my dealer $500 for that. Perhaps i'll go the cheap route and put a protective sticker/film over the broken light.......and hope if keeps water out. Man that's rediculous........$500 to replace a few square inches of glass......there has to be a cheaper solution!

 

[jville]

3m clear bra material might do the trick.

 

[jbiird317]

or rockblocker fog light covers

 

[GhostMercury]

film is the first thing i am going to buy for my lights to stop this from happening and any kind of chips

 

[BDL]

Potential good call on the 3M clear bra kit......pre-cut material for fogs and head lights run about $40 + tax/shipping. I'll probably just order these unless someone has a better solution.

http://www.invisiblemask.com/cgi-bi...trucks&year=2007&make=MAZDA&model=MAZDASPEED3