2017~2025 CX-5 Rear Differential Failure

[jadmt]

What do you know, it is literally right next to the battery, attached to another tube. Is there any mechanism that prevents liquids from getting in? This is good to know for when I wash the engine.

it is designed to allow only air to vent out. I think unless you are really flooding your engine bay you will be fine. I can tell on both my TC and diff the fluid had zero signs of moisture.

 

[N7turbo]

it is designed to allow only air to vent out. I think unless you are really flooding your engine bay you will be fine. I can tell on both my TC and diff the fluid had zero signs of moisture.

I foam, agitate, and rinse engines with my pressure washer.

I've done a 2011 Merdeces OM642.
I've done a 2004 Lexus V6.

I haven't done my car because it is new enough to not need it. But in year 3, I see the dirt is starting to accumulate.

 

[BoomerZoomr]

I foam, agitate, and rinse engines with my pressure washer.

I've done a 2011 Merdeces OM642.
I've done a 2004 Lexus V6.

I haven't done my car because it is new enough to not need it. But in year 3, I see the dirt is starting to accumulate.

Wouldn’t hurt to zip tie a plastic bag over any known vents. My transmission vent by the battery has a little gray cap apparatus on the end… I presume to let air pass freely both ways, but not let water in.

 

[jadmt]

I foam, agitate, and rinse engines with my pressure washer.

I've done a 2011 Merdeces OM642.
I've done a 2004 Lexus V6.

I haven't done my car because it is new enough to not need it. But in year 3, I see the dirt is starting to accumulate.

I am over 3 years and 47000 miles and my engine bay still looks pretty decent. I was changing plugs on my buddy's CX50 turbo the other day and he is at 40,000 miles and 3 years and his engine bay was really dirty.. we do the same kind of driving so not sure why his was so bad.

 

[BoomerZoomr]

2025 transmission vent

 

[AL Cx5]

are you postitive? my ram 2500 does and seems like you would be blowing seals without it able to vent. it should be on the axle tube.

No tube, yes a breather.

 

[Mulligan]

Anybody have suggestions on which sockets work best and any other tips to R&R the fill and drain plugs, both up front and in back?

Tekton sells an "extra-shallow" 23mm socket that's only 0.85" tall (Item #SHD11123). It's so shallow that using it with an average size clicker-type torque wrench might allow access to the differential fill plug despite the tight clearance. I needed a new torque wrench and found Tekton has one with a thinner than average head (Item #TRQ51402), so I bought it too. With the combination of the extra-shallow socket and the thin-head torque wrench, there's all kinds of clearance at the differential fill plug. I haven't done the fluid check yet, but am confident these tools will make the job easy. By the way, the torque wrench is very nice, much nicer than my 15 year-old Craftsman clicker torque wrenches.