I just created this custom iPhone holder / charger for my 2018 Mazda CX-5. I created it by combining two products that I purchased on Amazon.com (see parts below). I did this so I could securely mount my iPhone between the air vents and charge it using a MagSafe style charger. The total cost was about $55 (if you have Amazon Prime).
Parts acquired from Amazon.com:
https://www.amazon.com/dp/ (commissions earned) (as of 3/8/22 costs about $32)
https://www.amazon.com/dp/ (commissions earned) (as of 3/8/22 costs about $22)
Assembly Instructions:
1. On the Beerte iPhone holder, remove the ball-joint assembly from the unit.
2. On the Syncwire Magnetic Wireless Car Charger, remove the ball-joint assembly from the unit.
3. Swap the ball-joint assemblies (Beerte ball-join goes to Synchwire and Syncwire goes to Beerte).
4. That's it!
Parts acquired from Amazon.com:
https://www.amazon.com/dp/ (commissions earned) (as of 3/8/22 costs about $32)
https://www.amazon.com/dp/ (commissions earned) (as of 3/8/22 costs about $22)
Assembly Instructions:
1. On the Beerte iPhone holder, remove the ball-joint assembly from the unit.
2. On the Syncwire Magnetic Wireless Car Charger, remove the ball-joint assembly from the unit.
3. Swap the ball-joint assemblies (Beerte ball-join goes to Synchwire and Syncwire goes to Beerte).
4. That's it!