CHECK ! what is hkP on the Blitz DTT

[SirJaime]

OKI just lost everything I just typed in here ! But I will try this again.

I did NOT blame any body but Blitz using UK's Metric system !

And I know ther are no converters for hkPa sence ther is no such thing ( as far as I can FIND ) I know Hectopascal & Kilopascal if you have read my post u should of seen this by now !

And For WHAT line I used ? I used the very line that was called for in the photo of the web site i hav in this post ! But I first had it hooked up to the 1 just below that 1 , but I did not crank it up cuz I made a last check to make sure I had it done exactly the way it said ! ! ! !
So... I changed it to that 1 in the picture , but now I think I'm going to change it back , HELL it cant hurt !

Ass wipes @ Blitz wont write me back !


Installtion of the BLITZ DTT DC II
http://church56.tripod.com/blitz.html

 

[SirJaime]

Hey -7.1 is normal, that is what mine reads. What you are reading is vaccum. If you undo your hose from your boost gauge and put your finger on it you will notice that it is sucking, that is vaccum. When you start to boost it should go into positive numbers, then it is reading your actual boost. Vaccum is perfectly normal when you are not creating boost. Don't worry about it nothing is wrong. As far as it not reading above 0.00 I don't know what to tell you, either it is hooked up wrong, you have your boost turned way down, or your boost gauge is faulty. But you are reading the correct vaccum either way. Good luck.

LOL Thank You ! YloDmonMSP