Anyone make better motormounts?

[Turbo Matty P]

I'm looking to upgrade my 03 MSP with some better motor mounts. I figure this is a pretty common piece and surely somone out there makes some for the MSP, hell even the MP3 or base Protege's would work. Thanks

 

[melicha8]

www.awrracing.com

 

[RAAZ227]

DITTO!!! Just got mine.... BEAUTIFULL MOUNTS I tell ya!!


I was like

 

[Albert]

How hard was it to swap them?

 

[RAAZ227]

Cake walk..... Havn't put them in yet. But. All you do is take a floor jack will a block of wood on it and rest it under the area of the mount your taking off. Then take an air gun and pull the mount out, and then out the new one in. Not that hard!! Repeat for the other mount.

 

[RAAZ227]

Cake walk..... Havn't put them in yet. But. All you do is take a floor jack will a block of wood on it and rest it under the area of the mount your taking off.


Jack under the motor that is.

 

[blynzoo]

Um, that will work with the front one. The rear mount is a $%*( $#^ pain to get in compared.

 

[igdrasil]

Yeah I have both and the front one is a piece of cake.


Now the rear is another different story. Installing a turbo is easier that installing the rear mount.

 

[PaulMP3]

hehe, i am scared to attempt mine. hence the signiture. im waiting till i get lift access.
Just take a look and you will see why.

 

[RAAZ227]

Yeah I have both and the front one is a piece of cake.


Now the rear is another different story. Installing a turbo is easier that installing the rear mount.

naaaaa.... it can't be that bad. Now swapping a clutch is a Biatch! Pain in the...... (moon)

 

[Turbo Matty P]

Anyone actually test these on the track? Some Hond-ites at the track were showing me there RSX's and told me my axle-hop problem was the exact same as theirs, but the motomounts all but cured it. Now they launch like the cars are stolen. If only I could clutch dump at 4K rpms. I might put out some respectible numbers!

 

[LinuxRacr]

My AWR Thread

Peep this out: http://www.mazdamp3.com/vbb225/showthread.php?s=&threadid=17958