Search results

and on the coolest note I should be sporting a good 400whp. I also forgot pulley kit and cams too. I want to start drooling. also I found out the 1.8L audi uses four lug rims too. small world~

I am into DIY, so that's why I traded my car for an Audi A4, '02 3.0L with 43k miles on it and priced right at 16k. I'm planning to get an intake manifold, throttle body spacer, headers, and super charger. It has two subs stock, so and twelve speakers sound system. I am getting it tinted and...

i am doing a barter, she goes to the chinese markets i'm going to the show

tommotorsports.com. I do want to do THE TURBO. I even found a kit with a garrett for 1595!! full kit too. I was thinking about replacing the head too with the bored 1.8L from protegegarage. sigh.

NOW HERE IS THE SPRINGS!!!!!! rear and at an angle front setup that and also I prepped the rear panels for their new speakers I'm getting from blaupunkt, tomorrow i'll do the front I almost forgot here is the way it looks with tire on. It was a 2" drop. not a bad ride either. Can't even...

i think 16"s will be safe but I'm woried to do 17" I think if i do 16" it would be perfect because there's about 2.75" gap left or one foot to be jammed in there

depends where i am in the power band, it really just helps the fuel injection and keeps the from retarding... NOW HERE IS THE SPRINGS!!!!!! rear and at an angle front setup that and also I prepped the rear panels for their new speakers I'm getting from blaupunkt, tomorrow i'll do the front I...

no problem pm anytime, it has every vehicle on there

This is a new list of turbo kits I found at different sites. Ranging from an amazing $1599-$2899 all excluding shipping. One of these actually can be interchanged from the T25 to the T25BB. Here they are www.importperformanceparts.net -{T25}Extreme(56% gain @6psi) or Superior(30% gain @6psi)...

after much digging and hardcore research your answer is this..... po113= air intake temp circuit, high put po118= engine coolant temp circuit, high input po123= throttle position or pedal position switch circuit what does all this mean??? check your ignition system, air intake sensor and...

on it

will a clutch from any 99+ sedan protege work?? meaning the 1.8 on a 1.6??? give options please

no no no. Well I know that in the beginning, the first 20 miles, there is a possibility of noise. There should not be sounds coming after that, ever. I think that the rotors that ebc sent you are in someway defective. Unless you hit them on with a hammer or something I bet they would take them...

I'm going to the orlando and the atl hin!! I hope to see alot of mazdas there as for I Need to see what's been done. Besides it's easier than dreaming in mind~ I went to the the drift competition in Miami and there was only 1 protege there, an 00 dx like mine but barely anything done. The guy...

stage 1 or two? will any one fit for the 1.6 as long as it's the sedan??? (attn)

~~~update~~ So i found out what was wrong. It was a loose screw between the header and the cat. Also timing was adjusted which I was planning on getting done anyway. Code gone, engine back to itself.

But I have a question first. I had the mil/cel light on so I got the reader because there's a couple of people who do care stuff in my neighborhood. But I got the code P1504: Idle air control circuit malfunction.... causes; 1>Intake leak (nope, throttle body mechanical condition/ failed...

welcome!!!!

Just got the muffler and springs from a buddy in the west coast~ anyone know where to get a stage 2 clutch???

this one