Recent content by Oldasdrit

i already tryed that but still nothing as of right now i cant think of anything either, but thank you for your help

i used an add link and put it into the wiper fuse location

i took the battery out of the car so i could have room to run the wire up to the 02 sensor so i could tie it off to the stock wiring harness. i put the battery back in now the head does not flip back

hi guys i was putting a/f guage in this last weekend and i disconnected my battery. now the head of my radio will not flip back. i have already pushed on the top left hand corner of the face and not a thing. i checked the fuse in the lower left hand kick panel fuse is good. now is there a nother...

sorry i didnt get back to on the weekend, I think the sale peep i talk to when i was there was Matt can not rember his last name that what happen when u get old as dirt . It piss me off because i saw that dam mark on the rim when it was on there show room floor . I wish i could have talk to...

There 4 blots, lost the top right hand blot at about 3000 miles. I got new bolt from dealer put some hight-temp rtv silicone on it ,now i got 13,000 miles NP mite want to give it a try it work for me .

Well it 106 f. out side ATM were iam at ( So.Calif.) and i use the AC alot at this time of year it heat soak with a so so IC but u take the good with bad on a turbo car . I readed a car mag. test on a EVO 8 that could not break into the 100 MPH range at a track in So Calif. it was over 100 when...

Hi i think that car was the one they had on there show room floor. I look at it when i was getting my MSP from Anaheim Mazda (i got sunlight silver ) check the passer rear rim for a mark on the out side edge of the rim. If it is the one iam thinking of, see if u can have them replace the rim...

It mite be that the line from the BOV is to close to the MAF .It look from the pic. that it joins every close to the MAF and it mite be messing up the reading the MAF is getting at a idle. Just some thing to look at maybe .

The pennzoil synchromesh oil meets GM specifiction #9985648 and chrysler MS9224 for synchromesh oil. i think more than likely pennzoil makes the stuff for GM. pennzoil synchromesh oil will not hurt yellow metals such as bronze,brass and copper wicth is what most synchroners are made out...

I use pennzoil synchromesh at 5 dollars a quart in my msp. I put in at a 1000 miles and got 8000 on the car now it works GREAT it one of the best gear oils i have try. I told a friend about it he put in his car with over a 100,000 miles on the car he said his trans work like new again u can get...

Well i got my car flash and it was like night to day . My car is all stock , and has ran great sent the flash. but it like what the other peeps on the board said each car is diff. Only u can make the call on what u want to do.

well out a the track today 1500 rpm and under no wheel hop . Any thing over 1500 rpm wheel hop big time it was like a on off swicth hehe.

I just ran my car today for the first time . Wheel hop killing me . It ran a best of reaction time .552 2.504-- 60 ft. 6.632--330 ft. 10.060-- 1/8 et. 71.56--1/8 mph...

I go for one. I want to keep the stock look but would like one that work better than the stock one .