2012+ wiring diagram alarm / remote start

[chad99]

Hey guys planning on installing a remote start pke alarm. Anyone know the wire colors and location for a 2013 sport
Thanks

 

[Vasy]

Attached are the instructions for installing Mazda remote starter.
I can't imagine aftermarket will be much different, maybe a few wires, but will give you good idea.

 

[chad99]

Nice, thanks Vasy, now I just need to probe the ignition switch wires, simple enough.
They sure give you a ton of info, almost fool proof
Thanks again

 

[chad99]

Just putting this here for others:

DIRECTWIRE WIRING INFORMATION - MAZDA / MAZDA5 / 2013 / Remote Start

12volts blue/black (40A) + ignition switch, white 8 pin plug, pin 8

Starter blue/red + ignition switch, white 8 pin plug, pin 5

Ignition blue + ignition switch, white 8 pin plug, pin 1

Accessory black/red + ignition switch, white 8 pin plug, pin 6

Second Accessory black/white + ignition switch, white 8 pin plug, pin 7

Keysense blue + ignition switch, white 8 pin plug, pin 2

Power Lock blue -1000 ohms either kick or BCM behind glove box, white 24 pin plug (6), pin 14

Power Unlock (same as power lock) -

Lock Motor red/blue to red/yellow 5 wire either kick or BCM behind glove box, white 16 pin plug (5), pin 8

Unlock Motor red/black 5 wire either kick or BCM behind glove box, white 16 pin plug (5), pin 7
Parking Lights+ blue/black + passenger kick, harness to rear

Parking Lights- brown/red - headlight sw or BCM behind glove box, blue 24 pin plug (2), pin 23

Hazards blue/yellow - hazard sw or BCM behind glove box, blue 24 pin plug (2), pin 7

Turn Signal(L) black/red + pass kick or BCM behind glove box, white 16 pin plug (5), pin 3

Turn Signal(R) red/white + pass kick or BCM behind glove box, white 16 pin plug (5), pin 2

Reverse Light blue/white + pass kick or BCM behind glove box, gray 24 pin plug (1), pin 9

Door Trigger white/blue - N.C. either kick or BCM behind glove box, white 24 pin plug (6), pin 4

Dome Supervision yellow/black - pass kick or BCM behind glove box, white 16 pin plug (5), pin 15

Trunk/Hatch Pin red/black - pass kick or BCM behind glove box, white 24 pin plug (6), pin 15

Hood Pin gray - N.C. BCM behind glove box, gray 24 pin plug (1), pin 17

Trunk/Hatch Release purple/yellow (rear handle switch) - pass kick or BCM behind glove box, white 24 pin plug (6), pin 8

Factory Alarm Arm blue/orange (driver door key lock) - either kick or BCM behind glove box, white 24 pin plug (6), pin 2

Factory Alarm Disarm lt. green/red (driver door key unlock) - either kick or BCM behind glove box, white 24 pin plug (6), pin 13

Disarm No Unlock (transponder and ignition)

Tachometer black/white, black/yellow, black/blue, or blk/org ac any fuel injector, white 2 pin plug, pin 1

Brake Wire red/yellow + brake switch, white 4 pin plug, pin 4

Parking Brake brown - pass kick or BCM behind glove box, blue 24 pin plug (2), pin 9

Horn Trigger purple/white - horn switch or BCM behind glove box, blue 24 pin plug (2), pin 11

 

[chad99]

FYI anyone that is planning on installing an alarm, you have to use the door trigger mentioned in the Mazda remote start guide above posted by vasy, the one I listed from Directwire is only the drivers door trigger.

 

[Silentnoise713]

Attached are the instructions for installing Mazda remote starter.
I can't imagine aftermarket will be much different, maybe a few wires, but will give you good idea.

Thanks Vasy. This is awesome to have. Does your source have this for the previous gen?

Just putting this here for others:

DIRECTWIRE™ WIRING INFORMATION - MAZDA / MAZDA5 / 2013 / Remote Start

12volts blue/black (40A) + ignition switch, white 8 pin plug, pin 8

Starter blue/red + ignition switch, white 8 pin plug, pin 5

Ignition blue + ignition switch, white 8 pin plug, pin 1

Accessory black/red + ignition switch, white 8 pin plug, pin 6

Second Accessory black/white + ignition switch, white 8 pin plug, pin 7

Keysense blue + ignition switch, white 8 pin plug, pin 2

Power Lock blue -1000 ohms either kick or BCM behind glove box, white 24 pin plug (6), pin 14

Power Unlock (same as power lock) -

Lock Motor red/blue to red/yellow 5 wire either kick or BCM behind glove box, white 16 pin plug (5), pin 8

Unlock Motor red/black 5 wire either kick or BCM behind glove box, white 16 pin plug (5), pin 7
Parking Lights+ blue/black + passenger kick, harness to rear

Parking Lights- brown/red - headlight sw or BCM behind glove box, blue 24 pin plug (2), pin 23

Hazards blue/yellow - hazard sw or BCM behind glove box, blue 24 pin plug (2), pin 7

Turn Signal(L) black/red + pass kick or BCM behind glove box, white 16 pin plug (5), pin 3

Turn Signal(R) red/white + pass kick or BCM behind glove box, white 16 pin plug (5), pin 2

Reverse Light blue/white + pass kick or BCM behind glove box, gray 24 pin plug (1), pin 9

Door Trigger white/blue - N.C. either kick or BCM behind glove box, white 24 pin plug (6), pin 4

Dome Supervision yellow/black - pass kick or BCM behind glove box, white 16 pin plug (5), pin 15

Trunk/Hatch Pin red/black - pass kick or BCM behind glove box, white 24 pin plug (6), pin 15

Hood Pin gray - N.C. BCM behind glove box, gray 24 pin plug (1), pin 17

Trunk/Hatch Release purple/yellow (rear handle switch) - pass kick or BCM behind glove box, white 24 pin plug (6), pin 8

Factory Alarm Arm blue/orange (driver door key lock) - either kick or BCM behind glove box, white 24 pin plug (6), pin 2

Factory Alarm Disarm lt. green/red (driver door key unlock) - either kick or BCM behind glove box, white 24 pin plug (6), pin 13

Disarm No Unlock (transponder and ignition)

Tachometer black/white, black/yellow, black/blue, or blk/org ac any fuel injector, white 2 pin plug, pin 1

Brake Wire red/yellow + brake switch, white 4 pin plug, pin 4

Parking Brake brown - pass kick or BCM behind glove box, blue 24 pin plug (2), pin 9

Horn Trigger purple/white - horn switch or BCM behind glove box, blue 24 pin plug (2), pin 11

This is a great reference! Can you pull the same for the previous gen, say 2008 model? Thanks.

 

[chad99]

Battery BLACK & BLACK/YELLOW (+) IGNITION SHWITH HARNESS
Ignition 1 BLUE (+) IGNITION SWITCHHARNESS
Accessory 1 VIOLET (+) IGNITION SWITCH HARNESS
Accessory 2 BLACK/RED (+) IGNITION SWITCH HARNESS
Starter 1 BLACK/BLUE (+) IGNITION SWITCH HARNESS
Anti-Theft Type UNIVERSAL IMMOBILIZER
Anti-Theft Descript THE KEY SENDS AN RF SIGNAL TO THE BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER
Key Sense WHITE/BLUE (-) IGNITION SWITCH HARNESS
Tachometer BLUE/BLACK (AC) AT PCM MODULE ON DRIVERS SIDE FIREWALL UNDER HOOD
Speed Sense GREEN (AC) AT PCM MODULE ON DRIVERS SIDE FIREWALL UNDER HOOD
Parking Lights GRAY/BLACK (+) BCM MODULE BEHIND GLOVEBOX
Low Crr. Pk Lights BROWN/RED (-) BCM MODULE BEHIND GLOVEBOX
Brake Lights GREEN/YELLOW (+) SWITCH ABOVE BRAKE PEDAL
Reverse Lights RED/YELLOW (+) IN HARNESS IN PASSENGER KICKPANEL TO REAR
Horn VIOELT/WHITE (-) IN HARNESS AT STEERING COLUMN
CANbus RED & BLUE (DATA) DATA LINK CONNECTOR

Taken from here
http://www.the12volt.com/installbay/forum_posts.asp?TID=123459