What have you done to your MSP today?

I had in mind doing to custom Wide body work to fit thicker wheels with lip in the back and same in the front. let me see if i can find the link to show you what i would like to do.

thats a step or 2 beyond what I'm talkin bout... I'm just talkin about getting as much rubber under the body you have now as you can...
 
I had in mind doing to custom Wide body work to fit thicker wheels with lip in the back and same in the front. let me see if i can find the link to show you what i would like to do.

RICE ALERT..... RICE ALERT..... RICE ALERT.... If this had been an actual emergency, you would have been instructed to shake your head, avert your gaze, and be grateful he didn't mention Lambo doors...(nailbyt)
 
I'd say do it like they did on the Speed World Challenge cars (Tri-Point) very subtle flares up front and a nice roll on the rear. That looked plain sick to me!
 
I'd say do it like they did on the Speed World Challenge cars (Tri-Point) very subtle flares up front and a nice roll on the rear. That looked plain sick to me!

Never seen them, post a link. even tho this thread is about what have you done to your MSP, this is basically what i want to do to mine.. lol lol so i believe we are not thread Jacking this thread..
 
I can't find the exact picture I'm thinking of. Its oh so subtle, but looks soooo good. Man I want one of those old Tri-point cars...
 
arent the rx8 wheels +55 offset?

and lol at the big tires thing. you are trying for so much power, so you might need it. with as much money as you have put into it... you might as well go with some sort of wide body fenders to get some meat under there. i wouldnt do spacers. that seems like a cheap way of getting the looks.
 
I looked at my front end today, my 2003.5 lip is falling off haha, the 3m dubble sided tape didnt hold for sh*t! how is the lip held on stockwise? I rather have it on there for good (this is after I take it off and make it in carbon fiber)
 
I looked at my front end today, my 2003.5 lip is falling off haha, the 3m dubble sided tape didnt hold for sh*t! how is the lip held on stockwise? I rather have it on there for good (this is after I take it off and make it in carbon fiber)

the 3 studs in each foglight hole?

I don't think the 3m tape I put on mine is doing ANYTHING....
 
there is no bolts for me in those holes, I cut them for my fog lights :)

Im thinking silicon.


OH, thats right.. well, welcome to why using the 03.5 lip with fogs sucks!..

silicon is what they use from the factory, and holy crap was it a b**** to get off. sounds like a plan to me!
 
my lip would fall loose until I got nuts on all three of those fog light studs. the 3m tape is just to add support around the edges.
 
OH, thats right.. well, welcome to why using the 03.5 lip with fogs sucks!..

silicon is what they use from the factory, and holy crap was it a b**** to get off. sounds like a plan to me!

I think it looks awesome with fogs and that lip :)
3668286967_3e673d1265.jpg
 
Oh and once I get it in carbon ( have to trim down the foglight holes some more so if a bulb goes i can replace it easyer then taking the whole lip off haha) im going to get enough paint to paint my whole car made up, and get the front bumper resprayed and make them install the lip with silicon, and install my carbon roof cap :)
 
Back