Need Camber Kit for 08 '5'

[DayOh257]

Suggestions? Where can I get one?

Thanks!

 

[schokie]

I assume this is what you mean?

http://www.spcalignment.com/PROD_DIR/SPC_PROD_SEARCH_DYN.cfm?cmd=Cam&cmd2=67420&cmd3=

 

[tillyspeed81]

I have the SPC kit on mine, my friend who did my alignment said it was a pain to adjust. He said he's done one (I think is was Atita's) using the Mazdaspeed kit from the 3, which corrects enough of the neg camber and is non-adjustable....hope that helps

 

[DayOh257]

Thanks. That should do it. I saw Corksport had a set, so it seems to be the same.

 

[MD5]

What about this for my 2006 5?

http://thmotorsports.com/Store/Product/ItmItem.aspx?ItemId=68819&Make=MAZDA

 

[DayOh257]

What about this for my 2006 5?

http://thmotorsports.com/Store/Product/ItmItem.aspx?ItemId=68819&Make=MAZDA

Wow. That looks pretty extreme. It says "2 per axle". Does that mean you need 4? $400 for a camber kits seems expensive for a mild drop... (eek2)

 

[schokie]

MD5 & DayOh: That's the same part # I posted above from SPC. It's the adjustable rear camber arm. 2 per axle, so $200 total.

 

[MD5]

Wow. That looks pretty extreme. It says "2 per axle". Does that mean you need 4? $400 for a camber kits seems expensive for a mild drop... (eek2)

The bad thing is I don't even want to drop it. I'm having premature tire wear on the passenger side rear due to excessive camber. Its eating the inside of the tire.

 

[DayOh257]

The bad thing is I don't even want to drop it. I'm having premature tire wear on the passenger side rear due to excessive camber. Its eating the inside of the tire.

Well, if it's stock height, you should be able to correct it via a regular alignment.

My issue is that I'm contemplating swapping in a set of MS3 springs, which would drop it about 1.5"

 

[MD5]

Well, if it's stock height, you should be able to correct it via a regular alignment.

My issue is that I'm contemplating swapping in a set of MS3 springs, which would drop it about 1.5"

There is no adjustment for rear camber (or so I was told).

 

[red headz]

Like Tilly - I also have the SPC adjustable rear camber arms. I am not sure what springs Tilly has, but I swapped out for the MS3 springs. They are okay. Ride height is good - not too harsh or soft, but much improved over stock. Sometimes the rear looks a little low.

Far as the rear camber arms. If I did it over again, I would get the MazdaSpeed RCA's. They are not adjustable, but really - who needs to adjust the rear camber? Nothing is wrong with my SPC's, but they were a pain to install and the adjustment is also a PITA.

michael.