Whats This?

[StealthWyvern]

Cool I gathered that from the below thread as well!

so far judging by this thread....

http://www.mazdas247.com/forum/showthread.php?t=123743636

you have the following


hard pipes
dg engine cover
injen cai
dg parts - grill, raido surround, pillars, shifter surround, gage surround, (surprised that i didnt see the arm rest cover and air bad cover.)
shift knob
gauge rings
altezza tails

catless mid pipe - not installed.

 

[HelloimJared]

and that doesnt really answer my question.... btw where are you from?

haha my bad I though I was already on my "mods" thread. thats why I just said look at page 1. lol

but yea, thanks for the list!

 

[slavrenz]

Hey, so, correct me if I'm wrong, but that midpipe can only work with a header, right? I say that because it has the bung for the O2 sensor like the standard front J-Pipe, but it doesn't curve up to meet the front cat like the J-Pipe would. And if I'm not mistaken, most of the headers for our cars curve down to meet that pipe horizontally, right?

Hopefully this makes sense, I'm just wondering about the geometry of getting your rear O2 sensor to fit in that pipe.

 

[StealthWyvern]

Hey, so, correct me if I'm wrong, but that midpipe can only work with a header, right? I say that because it has the bung for the O2 sensor like the standard front J-Pipe, but it doesn't curve up to meet the front cat like the J-Pipe would. And if I'm not mistaken, most of the headers for our cars curve down to meet that pipe horizontally, right?

Hopefully this makes sense, I'm just wondering about the geometry of getting your rear O2 sensor to fit in that pipe.

um.... its turbo not NA. The MSP has a seperate S and J pipe. you can get a catless midpipe with a built in j pipe or not.