Not sure who else has noticed, but our 2s have FoMoCo calipers on them. I just became horribly disappointed in Mazda, and my local dealership, after with about a month on new brake pads I was getting shake, shimmy, and diving under braking (all coming from the right hand side). Just over a month ago, when I had less than 500 miles of warranty left, I had to replace the brake pads, no big deal other than the fact that my right side pad from the inside of the caliper was worn WAY worse than the other 3 at an angle. I took the car to my dealership to inquire about getting the caliper checked for warranty and they pulled the caliper, looked at the pads and said it's normal and nothing a fresh set of pads won't fix. They then tried to get me to spend $170+ to have them put pads on (with a 5 day wait for them to get the pads into the shop) and I declined to replace them myself. Fast forward to this week when my brakes started acting up and I pulled the calipers again, found excessive amounts of brake dust inside the right hub cap and, big surprise the caliper is dragging and now I'm stuck with it because of a shady service advisor. Cleaned everything up with brake cleaner, a stainless brush, and compressed air, put the car back together, hoping that the cleaning might have put the caliper right and took a test drive. Now the car dives left on hard braking, the ABS doesn't engage (slid all over the effing place on a panic type stop from 40 mph) and I'm stuck with the effing bill because I was a dumbass and listened to the service advisor at Woodhouse Mazda. I sent a b****y email to their "customer care" department, along with a b****y email to Mazda about Ford parts on a JDM vehicle. I was under the impression that the JDM Mazdas were actually Mazdas, not rebadged Fords. Had I known there were Ford parts on it, I never would have bought it. Rant off...just had to get it out to a crowd that may just understand where I'm coming from...