Post a picture of your MAZDASPEED3

holy sickness batman! how did you do the blacked out heads and tails?

Its actually spray on tint. Cheap and effective. Dont go with to many layers though...even with just three coats the headlights are noticably dimmed.

2 questions.

1.)why a vented hood if you have a FMIC?(assuming you had before the FM)
2.)how is the front plate mounted? Everyone I've seen uses the tow hook

2 answers.

1) FMIC came after the hood. Decided I like the look too much to change the hood again. More aggressive this way. Not to mention it keeps the engine cooler. Two full tick marks on the temp gauge lower than with the stock hood.

2) Yea not my brightest moment, in my defense I was a bit sloshed, but the plate is drilled directly into the bumper. This is ok anyway due to the eventual bumper swap that will happen in the future. Not sure which one just yet. I like the Corksport CS but I'm not sure I want to lose my foglights.
 
Last edited:
IMG_0013.jpg
 
I did some of my interior trim in 3m CF got the idea from radarthis. It covered up the little bit of discoloration I had from ricey dash kit I took off while ago.

DSC00593.jpg


DSC00598.jpg


DSC00587.jpg


DSC00599.jpg




OLD pic of the exterior
mompics045.jpg
 
To ZoomDoom:

Nice decapitator you got there. Yeah, front plates are ugly, but it's less ugly than a major facial laceration if you get in a wreck.
 
Last edited:
Back