So last night I was driving my P5 around and no problems at all. When I go to work this morning, I start my car up. It won't shift into 1st, 2nd, 5th or reverse. It will go into 3rd and 4th. So I let it warm up finally it goes into gear. Then after driving to work and going out for lunch the transmission seem fine. 
A few months ago I installed my ACT 6 puck clutch with no problems. When I add new transmission fluid (3us qts. by the manual) no fluid comes out of the check bolt hole. I had asked a couple people on the forum and they said they had the same issue. I didn't want to keep adding transmission fluid because I didn't want the oil to "foam up". Could it be the fluid I used??? I used what the manual spec'd. Any info would be greatly appreciated.
Note: When I was driving the car last night I DID NOT drive it hard. I rarly do.
Thanks
Rob

A few months ago I installed my ACT 6 puck clutch with no problems. When I add new transmission fluid (3us qts. by the manual) no fluid comes out of the check bolt hole. I had asked a couple people on the forum and they said they had the same issue. I didn't want to keep adding transmission fluid because I didn't want the oil to "foam up". Could it be the fluid I used??? I used what the manual spec'd. Any info would be greatly appreciated.
Note: When I was driving the car last night I DID NOT drive it hard. I rarly do.
Thanks
Rob
