Msp lip help

[Protege5 Smoke]

I just bought a MSP lip for my P5 but like most things used, it didn't come with all the hardware. What I need to know is the size of the collar nuts (flange nuts) that go on the bolts around where the fog lights would mount. Installation instructions from Mazda say there should be 4 provided with the msp lip kit, but again I didn't buy it from Mazda. A Google search turned up nothing as far as protgs are concerned, only MS3, MS6, and Mx-5. I'm guessing it's either M6 or M8, by the size of the bolt but I don't have any laying around so I can test it. If anyone knows what size nut goes there, pls help a guy out.

 

[MrGiggles]

It looks like your typical M6x1.0 to me.

Pull a nut from your cruise control actuator, they are M6. If that's too small, it's most likely an M8x1.25.

 

[JDM323J48]

Nuts off the fog light brackets.

 

[booom]

Good luck with the install. Here's a link for installation instructions: Mazdaspeed-Protege-2003-3-5-Front-Air-Dam-Installation-Instructions

 

[booom]

It looks like your typical M6x1.0 to me.

Pull a nut from your cruise control actuator, they are M6. If that's too small, it's most likely an M8x1.25.

I remember it takes a 10 mm wrench to loosen/fasten those nuts. So, yeah M6

 

[Protege5 Smoke]

Thanks guys