mazdaspeed3 engine mount recall!! ATTN

appantly is a perfectly cromulent word.

I wonder if I should wait or call. I mean, I did just read this thread 9 minutes after the service dept closed.
 
Last edited:
I always thought it was cromulent, but there's no subtitles on The Simpsons..

Keep it on topic, folks, or I'll have to delete my post!
 
s***. You're right. NIB HIGH FOOTBALL RULES!


If someone can, post dealership fix, get a print out of exactly what was done. I know it's a bolt thing, but maybe get a break down. kthnxbye
 
ATTENTION: MazdaSpeed 3 RECALL!

MazdaSpeed Recall

--------------------------------------------------------------------------------

This is fresh off Autoliv.

We regret to inform you that retail delivery of certain 2007 MAZDASPEED3 models in your inventory must immediately be suspended. Mazda Motor Corporation had decided to conduct a voluntary Safety Recall (#4607F) to replace the No. 4 engine mount bolt on certain 2007 MAZDASPEED3 vehicles produced from June 28, 2006 through May 19, 2007.

Certain MAZDASPEED3 vehicles, the No. 4 engine mount tightening bolt may loosen if a sudden/rapid acceleration is repeatedly performed. If the vehicle is continuously driven under such condition, the No. 4 engine mount bolt may loosen and fall out or break, allowing the transmission to be out of position. In extreme cases, the driveshaft may become detached. If this occurs the vehicle will immediately lose power, come to a stop and be inoperable.

Action Required:
Beginning today, July 3, 2007, certain 2007 MAZDASPEED3 vehicles produced from June 28, 2006 through May 19, 2007 in your inventory must be inspected and repaired prior to customer delivery. Delivering subject vehicles without performing the necessary inspection and/or repair is prohibited. Failure to perform applicable recalls before delivery can result in extensive dealer fines and penalties from the Federal Government
Subject Vehicles:
Model VIN Range Build Date Range
2007 MAZDASPEED3 JM1BK34**71 603266-768653 June 28, 2006 thru
May 19, 2007
*The asterisk symbol can be any letter or number

Please note that some vehicles within this VIN range have been repaired at the ports before being shipped to your dealership. Please refer to eMDCS Warranty Vehicle Inquiry to determine if a vehicle is subject to this recall.

Parts will start arriving at dealers with affected units in inventory on July 3, 2007. Repair procedures will be available on MS3 and the eMDCS on July 3 as well.
 
Last edited:
How come it says: "Beginning today, July 3rd 2007" in the "Action Required" section?

I think even though it might be old, it is still important, and as I mentioned above, not so old I'm guessing, since it was just delivered today to the mazda dealership.

But hey cashmere; props for being a douchebag though.
 
Karma_hunden said:
How come it says: "Beginning today, July 3rd 2007" in the "Action Required" section?

I think even though it might be old, it is still important, and as I mentioned above, not so old I'm guessing, since it was just delivered today to the mazda dealership.

But hey cashmere; props for being a douchebag though.

thanks bud...

the recall was issued 2 days ago
 
aliennation95gt said:
yeah a dealer posted it yesterday!

btu still props for thinking for peeps safety!

true that ... true that ...

has anyone taken it in yet for the new mount ? i wonder if its just the bolt or the entire mount (headbang)
 
Karma_hunden said:
MazdaSpeed Recall

--------------------------------------------------------------------------------

This is fresh off Autoliv.

We regret to inform you that retail delivery of certain 2007 MAZDASPEED3 models in your inventory must immediately be suspended. Mazda Motor Corporation had decided to conduct a voluntary Safety Recall (#4607F) to replace the No. 4 engine mount bolt on certain 2007 MAZDASPEED3 vehicles produced from June 28, 2006 through May 19, 2007.

Certain MAZDASPEED3 vehicles, the No. 4 engine mount tightening bolt may loosen if a sudden/rapid acceleration is repeatedly performed. If the vehicle is continuously driven under such condition, the No. 4 engine mount bolt may loosen and fall out or break, allowing the transmission to be out of position. In extreme cases, the driveshaft may become detached. If this occurs the vehicle will immediately lose power, come to a stop and be inoperable.

Action Required:
Beginning today, July 3, 2007, certain 2007 MAZDASPEED3 vehicles produced from June 28, 2006 through May 19, 2007 in your inventory must be inspected and repaired prior to customer delivery. Delivering subject vehicles without performing the necessary inspection and/or repair is prohibited. Failure to perform applicable recalls before delivery can result in extensive dealer fines and penalties from the Federal Government
Subject Vehicles:
Model VIN Range Build Date Range
2007 MAZDASPEED3 JM1BK34**71 603266-768653 June 28, 2006 thru
May 19, 2007
*The asterisk symbol can be any letter or number

Please note that some vehicles within this VIN range have been repaired at the ports before being shipped to your dealership. Please refer to eMDCS Warranty Vehicle Inquiry to determine if a vehicle is subject to this recall.

Parts will start arriving at dealers with affected units in inventory on July 3, 2007. Repair procedures will be available on MS3 and the eMDCS on July 3 as well.

deja vu

i am not sure about other dealerships but we didn't receive any more information, or any parts today like they said in the email. my service director told me they should be in by the end of the week.
 
Yes, I dont even own an MS3. I was just trying to be nice yall.




[napoleon dynamite] GOOOOOOOOSHH [/napoleon dynamite]
 
Last edited:
don't worry about it
you were ahead of me but I went ahead and posted a new thread because it's a clean one with all the specifics
 
Back