Mazdaspeed springs on MS3

[jbiird317]

jbiird, so would it be safe to say since your Roadmagnet install you have not had any tire wear issues with no camber kit?

yep, roughly 1k miles on them and i have not noticed any uneven or extreme tread wear

 

[M3_Zoom]

yep, roughly 1k miles on them and i have not noticed any uneven or extreme tread wear

Good to know. Also there website claims it only drops the car 1.1" I'm not bashing them, but your car looks like it was dropped more than an inch. Do you have any clarification on that?

 

[jbiird317]

Good to know. Also there website claims it only drops the car 1.1" I'm not bashing them, but your car looks like it was dropped more than an inch. Do you have any clarification on that?

i dunno, thats what they told me. I didnt measure before i dropped it off to them cuz they said that they would be doing it. I guess all I can say is that looks can be decieving. The ms3 is fairly low to start with, that could have something to do with it

 

[Ahjun]

So what version do you have and what version are the springs off the RoadMagnet website?

Im really interested in buying the springs...so do you think I should wait a while to see wassup on the site?

 

[jbiird317]

So what version do you have and what version are the springs off the RoadMagnet website?

Im really interested in buying the springs...so do you think I should wait a while to see wassup on the site?

i have the prototype version. Roadmagnet has the final versions designed and is waiting on me to make them and install them. Unfortunately, work has sent me to california for a few months so getting down to baltimore for the finals has been tough. The ones that you order on the website will be the final versions. I hope to have them on in ~3 weeks when I am home from CA.

 

[GhostMercury]

No, I'm just saying it tucks a little. Look at the pictures. His car is level. You are assuming the front and rear fender lines are the same. They are not.


OZ ultra leggera

/
what are the specs on those rims? cause i want them for my MSP

 

[SwampAss]

18X8 48mm ET 18ish lbs. Black is a semi gloss. $325.00 a piece through tire rack. 2 year warranty on finish. Awesome wheel.

 

[bast525]

yep never mind I'm not doing it if it requires camber plates.

Number one, that is going to cost a lot

Number two, I don't trust many people to set the camber properly on a car, an definately wouldn't trust any monkeys at my local Mazda service department

Number three... that's gonna be damn expensive...

Not worth it... the car is already plenty low and anyways I'm a poor bastard.