looking to build my motor

[msp727]

ok im looking to get pistons and rods and get them .20 overbored then have the blocked sleved and i was wondering if anyone has done this with the stock crank????

 

[yudkib]

yes, mazdaspeed2oo3.5 or whatever. he did .040 over though.

 

[dacquesta1]

where did he get the sleeves? i would have loved to gotten those. dammit lol

 

[Silverspeed2015]

i did mine with .020 over, i had it bored not resleeved. I had to get a new crank but it is the stock one.

 

[msp727]

did you have to get the crank after the build or during it cause it was bad?

 

[dacquesta1]

during...the crank is kind of an essential part of the motor. if your current 2.0L crank is out of round it can only be machined down .030.....the one that i had gotten was no good so i got a new one from the dealer.